You are browsing camaro6 
04-01-2017, 05:10 PM
|
#1 |
 Drives: 2017 V6 Camaro RS Join Date: Feb 2016
Location: Atlanta, GA
Posts: 106
|
Can someone look at this pic of under my hood?
It looks like when the dealer had my air intake box apart they didn't reattach it properly. I feel like it should be a perfect seal between the box entrance, foam seal, and rubber gasket. Can someone affirm this or compare it to their car?
Thanks! |
|
|
|
04-01-2017, 05:23 PM
|
#2 |
 
Drives: 2016 Summit White 2SS Join Date: Jan 2016
Location: Ontario
Posts: 423
|
Looks off a bit there not hard to line up but when I had mine apart the tube that goes to the throttle body was off also making it easier to line up. It should be snapped down in sequence back clip first then top fender clip side and finally the one that seals it bumper side.
__________________
2003 Cadillac CTS Sold
2006 Nissan 350Z Sold 2008 Cobalt SS/TC Sold 2016 Camaro 2SS Summit built 3/28/16 delivered 2018 Camaro ZL1 cancelled by GM 😡 2019 Corvette 2lt Z51 |
|
|
|
|
04-01-2017, 05:28 PM
|
#3 |
        Drives: 2016 2SS M6 Mosaic Blk Met-SOLD Join Date: Jun 2016
Location: KY
Posts: 2,934
|
You could probably adjust it and get it perfect if you want. When I installed my GM performance CAI, mine was a little off like yours.
__________________
Official Detailer of CamaroFest 8 & 9
https://www.autogeekonline.net/forum...st-8-pics.html https://www.camaro6.com/forums/showt...=521655&page=1 https://www.camaro6.com/forums/showt...=547470&page=1 https://www.camaro6.com/forums/showthread.php?t=527474 No one on Earth has detailed more Camaros. http://KirkTheDetailer.com |
|
|
|
|
04-01-2017, 05:39 PM
|
#4 |
 
|
Check the mount pins that are pressed into robber grommets, if ones out will offset it.
|
|
|
|
|
04-01-2017, 05:56 PM
|
#5 |
|
Drives: 2017 V6 Camaro RS Join Date: Feb 2016
Location: Atlanta, GA
Posts: 106
|
Yeah looks like the back clip isn't even in the hole. I'll try snapping them back in sequence.
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
