|
|
#15 |
![]() Drives: 2011 Ford Mustang 3.7 Join Date: Oct 2012
Location: Lynchburg, VA
Posts: 4
|
Thanks guys!! I'm the owner of the Mustang. I had heard from someone that a post had been made on this forum.
The car is my DD and gets 22-23 MPG in my daily commute (50/50 mix) and got 30.4 MPG on the trip home from Mustang Week this summer. I agree that if the Camaro wasn't so heavy that the bolt-on times would be very similar to the Mustang. That day at the track were my first passes on my new Spec Stage 1 clutch. I upgraded to be on the safe side. The clutch releases and engages quite a bit different than the stock clutch. I think with more practice with my launch techniques and some better DA that I can shave some more time off of my ET. I hope to get back to the track in the next few weeks! BTW, we do get plenty of the 'It's still a V6' comments on the Mustang forums! My weekend play toy is a 4 bolt Dart blocked 347 '93 Mustang GT with a Novi 2000 and a Tremec TKO 600 trans. Here is a couple of pic of my V6 with my regular street setup and a few pics of my '93 GT. ![]() ![]() ![]() ![]() ![]()
|
|
|
|
|
|
#16 |
![]() ![]() Drives: 2016 Corvette Z06 Blade Silver Join Date: Jun 2009
Location: Florida
Posts: 822
|
Nice Fox Body.
What does it run?Haters can hate on the V6.... 12 sec is great.
__________________
2016 2LZ Z06 Blade Silver
2013 ZL1 BLACK on BLACK <SOLD> Roto-Fab CAI 2010 2SS/RS BLACK on BLACK <SOLD> 3" MBRP 304 Stainless Exhaust Roto-Fab CAI |
|
|
|
|
|
#17 | |
|
Space Shuttle Aficionado
|
Quote:
|
|
|
|
|
|
|
#18 | |
![]() Drives: 2011 Ford Mustang 3.7 Join Date: Oct 2012
Location: Lynchburg, VA
Posts: 4
|
Quote:
I bought the car back in the spring and I'm still sorting out a few items on the car. The car made 529 RWHP and 470 RWTQ at just 5,900 RPM's and 11.8 pounds of boost when it was shutdown on the dyno because it maxxed out the fuel system. Over the winter I'm going to probably just 'bite the bullet' and buy the complete Aeromotive Stealth fuel system for the car and then get it retuned. The motor is supposed to be setup for 7K+ RPM"S and I have a smaller pulley to put on the blower. I think with the smaller pulley and spinning the car above 7K it should make over 700 RWHP. I also need to roll the rear 1/4 panel lips. They rub the tires some under hard accelleration. I think when I get everything sorted out the car should run high 9's in the low 140 MPH range. I can't wait!!! I also agree on the V6 haters!! A 12 second DD is nothing to be ashamed of!! Thanks!!
__________________
2011 Mustang 3.7: M6, 3.73's, full exhaust, CAI, tune. 1st NA 3.7 Mustang in the 12's. 12.60 @ 108.4 MPH
1993 Mustang GT: 347, Novi 2000, Tremec TKO 600, too much to list |
|
|
|
|
|
|
#19 | |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009
Location: Jefferson City, Missouri
Posts: 13,969
|
Quote:
Good looking car!
__________________
2016 Camaro 1SS - 8-speed - NPP - Black bowties
2010 Camaro 1LT V6 (Sold. I will miss her!) |
|
|
|
|
|
|
#20 |
|
PC Technician
Drives: 2016 Hyper Blue 2SS Join Date: May 2012
Location: North Dakota
Posts: 2,161
|
That's awesome! Thanks for sharing and joining our community to boot. You got two great looking Mustangs!
I'm partial to red lol
__________________
![]() |
|
|
|
|
|
#21 | |
|
I just like V8s
Drives: 2007 Corvette Z06 Join Date: Mar 2007
Location: Stuttgart, Germany
Posts: 919
|
Quote:
|
|
|
|
|
|
|
#22 | |||
![]() Drives: 2011 Ford Mustang 3.7 Join Date: Oct 2012
Location: Lynchburg, VA
Posts: 4
|
Quote:
Quote:
I have look around on the forum in the past, just never joined up. Red looks good on these cars, but also draws the eye of the law officers!! Quote:
I agree in a stick car the driver plays a big part in getting a good ET!!
__________________
2011 Mustang 3.7: M6, 3.73's, full exhaust, CAI, tune. 1st NA 3.7 Mustang in the 12's. 12.60 @ 108.4 MPH
1993 Mustang GT: 347, Novi 2000, Tremec TKO 600, too much to list |
|||
|
|
|
![]() |
|
|