Quote:
Originally Posted by jtgraham
Upon further testing I found that if I pump the clutch petal about 8 or 10 times when the car is not running I can shift into 1st easily. If I start the car it does the same. If I let it sit for a short time it is hard to go into 1st again. You can't suck out any air in the line from above in the brake reservoir like on gen 5's but I did find the lower air bleed on the passenger side of the trans and it appears to have a built in quick turn plastic handle to open and close. I can't tell if the slave cylinder is replaceable from the outside or if you can only access it when youchange out the clutch.
|
You will have to pull the transmission to remove the slave cylinder. I haven't pull mine on my tr6060 yet but on my t56 it was much easier to leave the bell housing in place and pull the transmission out of the bell housing with the slave cylinder mounted to it.