[The Maverick]

Originally Posted by Chutzpah

So just to follow up on this… the tow hook receiver IS installed on the LT1 crash bar and could possibly be accessed? The reason I’m asking is that I’d consider drilling an access hole in the bumper and moving my plate over it.

My '21 3LT RS has the receiver despite being covered up by the factory fascia. According to the following thread, the LT1's do as well:

https://www.camaro6.com/forums/showthread.php?t=613097

Restoring access to the tow-hook mount was an unintended practical benefit of my de-fresh facelift project!

https://www.camaro6.com/forums/showthread.php?t=608035

[Chutzpah]

Originally Posted by The Maverick

My '21 3LT RS has the receiver despite being covered up by the factory fascia. According to the following thread, the LT1's do as well:

https://www.camaro6.com/forums/showthread.php?t=613097

Restoring access to the tow-hook mount was an unintended practical benefit of my de-fresh facelift project!

https://www.camaro6.com/forums/showthread.php?t=608035

Does your receiver have threads? It didn’t look that way, but maybe it was just a shadow hiding them.

Thanks for sending along this information. I almost thinking I should see if I can fit / have made a specialty two piece tow hook in there. Two right angles and being able to screw the hook portion in from below the facia. Definitely not a priority though… just thinking out loud.

[The Maverick]

Originally Posted by Chutzpah

Does your receiver have threads? It didn’t look that way, but maybe it was just a shadow hiding them.

I hadn't noticed that the photo had such a smoothbore look, so I went out to the garage to double check. Turns out it was just the angle of the photo hiding the threads - the tow hook mounts up just fine!

[Chutzpah]

Good to know, thanks!