MSD BAP Vacuum Line Help!! - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

mbrusco103 · 04-03-2014, 01:50 PM

I am working on installing the AGP Twin turbo kit right now and i am trying to hook up the MSD BAP i have the wiring hooked up but im and not sure how to hook up the vacuum line. The intake manifold has a nipple on the side that has a hard plastic line running over the throttle body to a little solenoid. I dont understand how i can hook into that. Also i need to hook up an AEM Tru boost controller. Any insight would be very helpful and pictures would help alot too!

AGP Turbo · 04-03-2014, 03:43 PM

Your AGP TT kit came with a vac line assembly that was labeled where each line goes. The line that goes to your BOV. Measure 16" up that line from the BOV and cut it. Put a tee in there and run your line from the voltage booster to that. When we supply the voltage booster we include a 1/4"-3/16"-1/4" metal tee and a bunch of thick walled 5/32" vac line. Do that and zip tie all the connections and you should be good to go.

04-03-2014, 01:50 PM	#1
mbrusco103 Drives: 2011 2SS/RS (M6) 427 Twin Turbo Join Date: May 2008 Location: NJ Posts: 1,090 View My Garage	MSD BAP Vacuum Line Help!! I am working on installing the AGP Twin turbo kit right now and i am trying to hook up the MSD BAP i have the wiring hooked up but im and not sure how to hook up the vacuum line. The intake manifold has a nipple on the side that has a hard plastic line running over the throttle body to a little solenoid. I dont understand how i can hook into that. Also i need to hook up an AEM Tru boost controller. Any insight would be very helpful and pictures would help alot too! __________________ 2011 Camaro 2SS/RS ERL 427 M6 TT -AGP Twin Turbo 55/57 .83ar \| ERL 427ci \| Squash Fuel System \| Stainless Works Chambered 3" \| Mcleod RXT \| Factory Hurst Short Throw \| Black Forgestar F14s \| CTS V 6 Piston Brembo \| VIS AMS Carbon Fiber Hood \| Anvil Carbon Fiber Spoiler

04-03-2014, 03:43 PM	#2
AGP Turbo Drives: All things Turbocharged Join Date: Dec 2010 Location: AZ Posts: 1,199	Your AGP TT kit came with a vac line assembly that was labeled where each line goes. The line that goes to your BOV. Measure 16" up that line from the BOV and cut it. Put a tee in there and run your line from the voltage booster to that. When we supply the voltage booster we include a 1/4"-3/16"-1/4" metal tee and a bunch of thick walled 5/32" vac line. Do that and zip tie all the connections and you should be good to go.