10-01-2020, 10:20 AM | #15 |
Drives: 2017 Camero ZL1 Join Date: Nov 2015
Location: Texas
Posts: 130
|
That's very fair. Probably cheaper than most. Cam swaps on 6th gen are not cheap. I received several quotes and I think all were 24+ hours labor. I could have done labor myself except cam swap so in my case it made sense to have everything else done as added labor was minimal. Hope this helps.
__________________
2017 ZL1 A10
Dyno/Quarter Mile/Dragy 9.71@141.2 MPH so far. 2007 Z06 H/C/I/E Half Mile - 169 MPH. Sold. |
10-04-2020, 08:31 AM | #16 |
Drives: 2017 Camero ZL1 Join Date: Nov 2015
Location: Texas
Posts: 130
|
No new PB unfortunately but as they say 'that's racing'. Car spun hard first two passes. Last pass dropped tire pressure to ~18 PSI. Still spun but I stayed in it until it corrected itself. 60 foot was 2 tenths slower than last Friday but still managed a 9 second pass. This is best MPH car has trapped mostly due to DA and higher blend of ethanol. Power was there all night but after two years these Mickey Thompsons are done. Can't complain about spinning and running a 9.9.
Then on the way home with wife and her stuff in the car again tried another Dragy hit. Still need to do a solo one. Would've probably been a high 5.3 with just me in the car. Picking up DSS chromoly driveshaft and BMR on-car adjustable control arms today. Will update when new passes are made.
__________________
2017 ZL1 A10
Dyno/Quarter Mile/Dragy 9.71@141.2 MPH so far. 2007 Z06 H/C/I/E Half Mile - 169 MPH. Sold. |
11-19-2020, 06:02 PM | #17 |
Drives: 2017 Camero ZL1 Join Date: Nov 2015
Location: Texas
Posts: 130
|
I suppose it's time for an update. Car has been faster despite no added power mods. I did install driveshaft and control arms. Also had alignment done along with new tires. Did 9.71@141 and 9.8@145 at test and tune.
Then decided it was time to test Dragy again but solo at night with good weather. This is fastest time yet. On 9.71 pass it showed 5.48 60-130. Will update if the car runs any faster. Hoping to get a 9.6x in the quarter just need to make it happen!
__________________
2017 ZL1 A10
Dyno/Quarter Mile/Dragy 9.71@141.2 MPH so far. 2007 Z06 H/C/I/E Half Mile - 169 MPH. Sold. |
11-20-2020, 12:16 AM | #18 |
Account Suspended
Drives: '21 Wild Cherry ZL1 Join Date: Aug 2018
Location: WI
Posts: 2,082
|
Very nice!
Adjustable control arms I would guesstimate allow for pinion angle, what is yours set to? |
11-21-2020, 06:06 PM | #19 |
Drives: 18 ZL1-1LE, 10 JKU Join Date: Jul 2018
Location: AR
Posts: 585
|
You don't happen to have any video of that exhaust note do ya?
|
11-22-2020, 03:27 AM | #20 | |
Account Suspended
Drives: 2017 Camaro ZL1 A10 Join Date: May 2012
Location: NJ
Posts: 7,692
|
Quote:
For the record, if you're gonna spend that much then you might as well cough up a few extra bucks and swap out the blower instead of porting it. |
|
11-23-2020, 06:59 AM | #21 | |
Drives: 2017 Camero ZL1 Join Date: Nov 2015
Location: Texas
Posts: 130
|
Quote:
My page is public so this should work. Exhaust Note Went to a track rental this past weekend. No personal best ET but did a personal best 60'. Ran 9.7s twice with one pass being in +1500 DA. Will make a detailed post later this week.
__________________
2017 ZL1 A10
Dyno/Quarter Mile/Dragy 9.71@141.2 MPH so far. 2007 Z06 H/C/I/E Half Mile - 169 MPH. Sold. |
|
11-23-2020, 08:06 AM | #22 |
Drives: 18 ZL1-1LE, 10 JKU Join Date: Jul 2018
Location: AR
Posts: 585
|
Thanks! I have the SW catback, and hopefully ordering cam and headers this week...haven't heard the combo very much, sounds awesome!
|
11-23-2020, 08:28 AM | #23 |
Drives: 17 NFG ZL1 17 GTR 22 RS6 Join Date: Apr 2017
Location: Upper Marlboro MD
Posts: 625
|
you have videos withhow the exhaust sounds on ur car?
|
|
|
Post Reply
|
|
|