03-11-2019, 10:40 AM | #1 |
Drives: '17 ZL1 A10 Vert Join Date: Mar 2017
Location: SW Florida
Posts: 375
|
Turn signal issue
Last time I drove the car (like 3 weeks ago) I noticed the front passenger side turn signal was out.
Due to the weather I didn't have a chance to check it until yesterday. When I popped the hood, this is what I found. Has anyone experienced this? Is there anything I can do to prevent it? Everything snapped firmly back into place but I can't figure out how it popped out on its own. |
03-11-2019, 10:46 AM | #2 |
Drives: 2016 2SS Convertible Join Date: May 2012
Location: St. Louis, MO
Posts: 1,711
|
Maybe it was never fully snapped into the socket from the factory and it just took this long to work itself loose?
|
03-11-2019, 10:56 AM | #3 |
Drives: 2SS Hyper Blue Join Date: Jun 2018
Location: N. California
Posts: 234
|
Likely the case - that does happen.
__________________
2018 Hyper Blue 2SS - SOLD
|
03-11-2019, 01:02 PM | #4 |
Drives: '17 ZL1 A10 Vert Join Date: Mar 2017
Location: SW Florida
Posts: 375
|
Perhaps.
I'm just glad it wasn't the driver's side. That looks like a bear to get to. |
03-11-2019, 09:46 PM | #5 |
Drives: 2018 Camaro 2SS A8 Join Date: Jul 2017
Location: East Tennessee
Posts: 11,696
|
Not all that difficult, I was able to install an LED replacement after lifting and propping up the rubber flap that is only on the driver side. (Unless the ZL1 front is even less roomy than the SS, of course.)
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune 1100 - 1/30/18 | 2000 - 1/31/18 3000 - 2/06/18 TPW 2/26/18 3400 - 2/19/18 | 3800 - 2/26/18 4300 - 2/27/18 | 4B00 - 3/01/18 4200 - 3/05/18 | 4800 - 3/14/18 5000 - 3/16/18 | 6000 - 3/19/18 |
|
|
Post Reply
|
|
|