You are browsing corvette7 
05-13-2012, 08:14 PM
|
#1 |
 Drives: MG Join Date: May 2012
Location: USA
Posts: 1
|
Shift lever
NOT a Camaro guy but putting a 94 3.4L into an MGB. Have a T-5 WC from an 89 IROC and, of course, the shifter doesn't line up with the hole in the floor. To make it work I must get the lever apart. It seems to be two pieces joined close where it enters the top of the trans. There seems to be a rubber coupling inside the lever and I see no obvious way to separate them.
http://i1081.photobucket.com/albums/...1/IMG_8644.jpg HOPE the picture works............ |
|
|
|
05-13-2012, 08:34 PM
|
#2 | |
|
ace5.org
|
Quote:
A suggestion for the future....don't put this when you are asking a question on a camaro forum. 
__________________
Stock...For Now.
|
|
|
|
|
|
05-13-2012, 09:42 PM
|
#3 |
|
Drives: 2010 camaro Join Date: Aug 2011
Location: pa
Posts: 1
|
make the hole in the floor bigger or slide the shifter up from underneth the car
|
|
|
|
 |
|
|
