[Camaro EMT]

Originally Posted by JerTM

The bed mounted carrier can only be installed in a particular location depending on bed length. The longer bed mounts further back than the short bed. It's all dependent on where the underbed mounts are designed to go. You could leave the factory underbed mount but it will definitely rattle and clank due to the design of the tire hoist. However it is only one 15mm bolt to remove/install. They will also remove the heat shield as well. I suggest contacting the dealer and asking them to hold on to the original carrier if you want it just to make sure they don't toss it.

The cupholder lightning can go white. Red, green, blue, white, aqua, and a color fade are all options. There may be a color I am missing though. Before you sign the papers take a good look at the holes in the rubber part of the cupholder where the lights go through. They are a pain to make and the tech can easily mess up the rubber.

If the bed lighting is anything like the full size which is very likely is it LED and it's sufficiently bright.

Thanks @JerTM! If you were closer, I'd have you install the options when my truck arrives. Those were all questions I've had since I ordered the truck. I'm not sure when it's coming in. I ordered it on March 16 (ten weeks ago). The truck was built (VIN provided) the week of 5/15 and is still at the Wentzville plant with an event code of "4B00 - Bayed." I'm thinking something might be wrong with it as I understand this code can be used when a vehicle is pulled for QA.