Quote:
Originally Posted by Normagene
I was thinking about doing something with the rear gills. I don't like those vinyl fade strips or the plastic and/or metal insets. I'd like to get them cut open. Seen a few off the shelf kits, but they're bulky or only have one open slot. Some just look cheap and like a glob stuck on the side of the car.
So my question is has anyone seen a good look'n set? I imagine having them fabricated by a metal shop, plus then paint re spray, well that's just too expensive.
Anyway, just putting it out there, I'd appreciate any suggestions. Here's an example of one with only one slot, and just glued on top of the existing gills.
Attachment 681900 |
ACS is not cheap stuff but very good quality. The Gill insert is not just glued on. You have to cut the whole Gill section out. Take the back seat out. Rear side panels have to come off. Holes have to be drilled in the inside body frame to hold the panels in place once installed.