Chevrolet Corvette Stingray C7 Forum - View Single Post

shank0668 · 04-22-2014, 09:18 PM

Donor tub

Brackets for coils were bad, I took the top one off the old frame, cut out center, and fit into the bracket on the axle, welded in.

Random mess photo

Small patch on drivers side.

Floor was bad under roll bar.

I used the section from the old tub. Not a perfect fit but close.

Old rails

One side is in. The other is will be done by the end of the week. Have to patch some floors on the drivers side first.

One rail is painted

Going to paint the whole underside before it goes back together.
Driver side floor under roll bar is patched

I'm certainly no professional welder but I think they are pretty strong.

04-22-2014, 09:18 PM	#22
shank0668 Drives: '14 LML/'06 LJ/'76 Trans Am Join Date: Feb 2008 Location: Ohio Posts: 8,438 View My Garage	The one side of rails [IMG]http://i291.photobucket.com/albums/ll281/shank0668/01B7E4EE-5644-4B74-AF4A-E9B4****2EAC_zpsa5aurkh5.jpg[/IMG] Donor tub Brackets for coils were bad, I took the top one off the old frame, cut out center, and fit into the bracket on the axle, welded in. Random mess photo Small patch on drivers side. Floor was bad under roll bar. I used the section from the old tub. Not a perfect fit but close. Old rails One side is in. The other is will be done by the end of the week. Have to patch some floors on the drivers side first. One rail is painted Going to paint the whole underside before it goes back together. Driver side floor under roll bar is patched I'm certainly no professional welder but I think they are pretty strong.