Chevrolet Corvette Stingray C7 Forum - View Single Post - 1992 Chevrolet S10 restoration project with 2013 Camaro SS Wheels

bwk1971 · 11-05-2013, 09:16 AM

My mother passed away a couple of years ago, and I inherited her truck. The truck was actually my grandfather's truck and it only has 58K miles on it. But, as you can see from the pics, it wasn't well maintained. So, in memory of my mother, I decided to restore it as much as possible. I began with a new paint job and spray-in bedliner. Then, since I had my factory camaro wheels laying around, I decided to see if I could make them fit. Indeed they did. A set of 1 1/4" wheel spacers and I was in business. Next, an LS motor perhaps?

Name: IMG_3622.jpg
Views: 28449
Size: 200.2 KB

Name: IMG_3622.jpg
Views: 28449
Size: 200.2 KB

Name: IMG_3623.jpg
Views: 5953
Size: 121.8 KB

Name: IMG_3624.jpg
Views: 6519
Size: 175.6 KB

Name: IMG_3625.jpg
Views: 6633
Size: 158.8 KB

Name: IMG_3626.jpg
Views: 6948
Size: 189.4 KB

Name: IMG_3910.jpg
Views: 7379
Size: 258.9 KB

Name: IMG_3955.jpg
Views: 12891
Size: 251.5 KB

Name: IMG_3956.jpg
Views: 40776
Size: 225.9 KB

Name: IMG_3952.jpg
Views: 6217
Size: 282.7 KB

11-05-2013, 09:16 AM	#1
bwk1971 Res Ipsa Loquitur Drives: 2013 Camaro SS Vert Supercharged Join Date: Sep 2012 Location: Southern Maryland Posts: 726	1992 Chevrolet S10 restoration project with 2013 Camaro SS Wheels My mother passed away a couple of years ago, and I inherited her truck. The truck was actually my grandfather's truck and it only has 58K miles on it. But, as you can see from the pics, it wasn't well maintained. So, in memory of my mother, I decided to restore it as much as possible. I began with a new paint job and spray-in bedliner. Then, since I had my factory camaro wheels laying around, I decided to see if I could make them fit. Indeed they did. A set of 1 1/4" wheel spacers and I was in business. Next, an LS motor perhaps? __________________ "STREET LEGAL" 2013 Camaro 2SS/RS LS3 Convertible -- 2.9l Whipple Supercharger, CDC SportBar, Cordon CR-1 and MRR M017 wheels, Hex Vents, RPI ZL1 Splitter, CAI, Pfadt Tri-Y Headers, high-flow cats, ZR1 3 bar map sensor, ZL1 fuel pump, 3.875" pulley, ADM FPCM, 1LE PCV Oil Separator Kit, Elite Catch Can, APEX scoop and washer bottle relocation kit, Hotchkis lowering springs, BMR sways, BMR toe rods, BMR trailing arms, 620 rwhp, 564 rwtq, and tuned by Andrew Zurick of Complete Street Performance by way of Maryland Speed.