Hey guys and girls, a little on the bored side tonight so i thought i would share the install of my Rx catch can i bought for my dads vette.
Step 1 - Remove Passenger Engine Cover
Step 2 - Disconnect the 3 sensors that are "pointed" by my fingers
Step 3 - Remove the Pcv tubing from the Valley cover to the Pcv crankcase
Now the instructions say to mount the the lower hole near the tensioner belt, but the hex screw was wayyy to small and will have to get a another screw.
For now i mounted it to the engine cover stud.
Will be cutting the braided lines once we get a final resting place for the CC
