|
Passenger door
I just picked up my 2012 2LT and noticed that the passenger door,
at the bottom where it meets the rear quarter panel, seems to not
be flush. In other words, it looks like it is in about 1/2 inch just at
the bottom. The seams of the door are even so it's not a matter of realigning it left or right. If you pushed the door out just a little from the inside then it would be flush, for lack of a better example.
The dealer told me that since the seams were even that they
didn't want to start playing around with it, adjusting it, etc. and
possibly make it worse. He thinks it was the way the door was
molded. Is there such a thing as possibly just pushing out the
door or resetting it someway? No one else has noticed this so it
is not that evident but I know it's there.
Any ideas.
|