Quote:
Originally Posted by BigDan
The new 315/35/20" Nitto NT05R's are doing really well and have cut some nice 1.6 60ft's, but like you said you don't want diff problems from hard launch's which i'm also worried about since my last hard DR launch told me to service advanctrack system, some sensor wasn't happy but it went away on the way home.
|
I dont know man...it looks like very few are going to try and track an NA stock cube 5th gen so it might be up too poor little me....LOL. I am betting we will have to wait for prices to drop on used veicles to see a lot of them tracked...they are just not very strip friendly from the get go.
No one I have seen has cut any better than ~1.8 60 fts on the 20's with radials...you cant run a 315 on the 9 inch wide rims of the 5th gen. 275's is the end of the road unless you want to risk a malfunction. Even then I am not sure it would hook as well compared to the gt500 on 20 inch radials and SRA.
Like I said...the stang definitely hooks better from the get go...
I really wish I could try some 17 inch bogarts with slicks, some g-force axles, poly diff mounts, lower control arms, add some 4.10 gears and some good conditions. But ill be damned if you cant even get some gears...the richmond 4.10 gears are breaking on everyone and their is nothing else available yet.
I would like to try for mid 11's with that set up. I have a lighter 1SS which is lighter than stock...but I am 240lbs myself...which wont help a damn thing.