Quote:
Originally Posted by jtgraham
So I was able to jack up both side of the rear and get underneath. I found the driveline turns about 3/4 before the axle starts to rotate. The drivers side axle even pops out about 1/8 before rotating. The passenger side just spins and does not pop out before rotating. I 21k rear diff is on the way to replace this 108k abused one.
I pumped the clutch about 10 times and put it in first, started the car and there was no wheel movement at all until I let the clutch out about half way. I pushed the clutch back to the floor and the wheels stopped again so I guess there is no need to check for air in the clutch slave is there? I thing I am looking at some Trans work possibly?
|
Replace the diff and then come back to check the transmission. It's always a good idea to replace things that are for sure broken before you mess with things that may be broken.
The 1st gear syncro is probably the least likely to fail just because its not really used very often under harsh conditions in the first place. Downshifting at slow speeds from 2nd to 1st as you're coming to a stop and engagement from neutral to 1st when taking off.
Now maybe a shift fork being bent or the contact pad on it is deformed. But you would think you would have problems with 2nd also since they share that fork.
Maybe 1st gear alignment teeth at rounded out which could cause a rough kinda feel when moving into 1st, pretty much how a bad syncro would feel.