[m6-lt1]

I’ve done it twice without even lifting the car up. Smaller guy so I can just slide under there. Having said that I am literally working blind. So getting the screw out is the easier part. The trick is to get the right sized screw driver so it fits in that spot and between the exhaust suit case. Once the screw driver head is directly into the screw, press inward and turn as they screwed it in pretty tightly from the factory.

To get the new one in I used painters tape to tape the screw to the screw driver. I think I also try getting the screw through the hole before completing putting the new reflector in.

Hope this helps. Just keep working at it and you’ll eventually get it. You’ll be tempted to just go buy double sided tape multiple times but I promise you you can figure it out without it.