|
[CLOSED] Possibility to create a table in the signature
Hello,
I was wondering if there is a possibility ot use commands to create a table to better organize the signature section - to be able to see the whole picture and text next to it (right now lower part of picture is not displayed/cut off).
Is it possible? If yes then what commands to use?
BR,
Jarek
__________________
Camaro SS 2017 Convertible, 2SS trim, V8 6.2L 455HP 618Nm, A8, Silver
Mods so far: K&N oil air filter, rear lamps EU conversion with sequential turn signal, exhaust mod to 4 tips (non-NPP), LED rear fog light (EU requirement), Diode Dynamics LED markers.
Mods planned: Morimoto LED lamps set (front)

Last edited by Jarek; 12-03-2024 at 02:59 AM.
|