The 2014 Corvette Stingray Forum
News / Blog Register Social Groups Calendar Search Today's Posts Mark Forums Read

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.08 seconds. Search: Posts Made By: CamaroCracka
Forum: 5th Gen Camaro SS LS LT General Discussions Today, 02:24 PM
Replies: 12
Views: 395
Posted By CamaroCracka
Summit has a 415 short block for $4200, $6200 for...

Summit has a 415 short block for $4200, $6200 for GM LS3 long block. When my vert spun a rod I had a 416 built for 7k and installed for another thousand. That included a new clutch and a cam swap.
...
Forum: 5th Gen Camaro SS LS LT General Discussions Today, 02:09 PM
Replies: 5
Views: 157
Posted By CamaroCracka
Looks like the Spohn brace with the two...

Looks like the Spohn brace with the two additional sides to make a triangle. It might be good if you wanted to cut out the cross member to remove the oil pan and not replace it. One guy did that with...
Forum: 5th Gen Camaro SS LS LT General Discussions Today, 02:06 PM
Replies: 8
Views: 342
Posted By CamaroCracka
I like the ones with the chrome naked lady on...

I like the ones with the chrome naked lady on them.
Forum: 5th Gen Camaro SS LS LT General Discussions Today, 02:03 PM
Replies: 1
Views: 36
Posted By CamaroCracka
You may have four front wheels on the car....

You may have four front wheels on the car. Measure the inside of the tire barrels to see if they are the same width. Stock wheels are 20x8 and 20x9. You can also look on the back of the wheel and see...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) Yesterday, 08:50 AM
Replies: 25
Views: 671
Posted By CamaroCracka
Pretty sure the Mantic instructions said a light...

Pretty sure the Mantic instructions said a light coat of grease on the input shaft. I could be wrong, but I did the same thing, sliding the clutch discs on to the input shaft to make sure they were...
Forum: Forced Induction - V8 Yesterday, 08:41 AM
Replies: 9
Views: 233
Posted By CamaroCracka
I don't have AGP, but my single set up loves to...

I don't have AGP, but my single set up loves to melt loom in that area. This stuff holds up to the heat better than any other loom I have found, except maybe the silicone covered stuff, which is not...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-10-2024, 07:33 PM
Replies: 6
Views: 153
Posted By CamaroCracka
My fan plug burned with just the stock fans...

My fan plug burned with just the stock fans running on it. I would definitely just tap into the fan feed as trigger for an additional relay with a separate power source.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-09-2024, 02:29 PM
Replies: 34
Views: 1,153
Posted By CamaroCracka
Definitely, maybe it was because mine was built...

Definitely, maybe it was because mine was built during Covid, but I twisted it in half at a lot less power. Looked to me like the weld penetration was bad and it was taken care of, but it makes me...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-07-2024, 12:30 PM
Replies: 7
Views: 361
Posted By CamaroCracka
That half liter difference between the SS and Zl1...

That half liter difference between the SS and Zl1 TR6060s is the cooler lines and cooler. When I put diff coolers on my cars they took approximately 4.5 quarts to refill with the cooler in place.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-07-2024, 12:21 PM
Replies: 16
Views: 765
Posted By CamaroCracka
The stock 355 l99 pump can cavitate at high rpm...

The stock 355 l99 pump can cavitate at high rpm aerating the oil. They used to run a similar pump in the LS4 5.3 that I ran for a while in another engine. Low cost pump that builds tons of pressure,...
Forum: Suspension / Brakes / Chassis 04-07-2024, 12:13 PM
Replies: 6
Views: 360
Posted By CamaroCracka
Here is what I have.

Here is what I have.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2024, 10:47 AM
Replies: 1
Views: 178
Posted By CamaroCracka
Long duration cams respond well to steeper gears....

Long duration cams respond well to steeper gears. Superchargers tend to need less gear but centrifugals come in later so you should be ok if you don't get too crazy on the power level.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-02-2024, 05:25 AM
Replies: 9
Views: 279
Posted By CamaroCracka
The front is the harder part to get in the air,...

The front is the harder part to get in the air, if you get a long reach, low profile jack, you won't need any blocks to get a jack under it. Hell, even at stock height you really need a long reach,...
Forum: Chevy Camaro vs... 04-01-2024, 02:14 PM
Replies: 10
Views: 7,446
Posted By CamaroCracka
That would have actually been a very cool option...

That would have actually been a very cool option as there are so many turbo 5.3s you would have had turbo Gen6s everywhere. Reminds me of the low option muscle cars we drove in the 80s. We could not...
Forum: Forced Induction - V8 03-29-2024, 07:43 AM
Replies: 2
Views: 195
Posted By CamaroCracka
I'm at about that at WOT on E85 using a AEM gauge.

I'm at about that at WOT on E85 using a AEM gauge.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-27-2024, 07:09 PM
Replies: 9
Views: 386
Posted By CamaroCracka
Even my 02 Silverado has an oil level sensor on...

Even my 02 Silverado has an oil level sensor on the side of the pan. Pretty common on LS.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-27-2024, 07:04 AM
Replies: 43
Views: 1,620
Posted By CamaroCracka
It's already happening for the 6th Gens. You are...

It's already happening for the 6th Gens. You are starting to see threads where their parts are no longer available.

I don't think Mary Barra sees muscle car enthusiasts as a GM market anymore,...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-26-2024, 07:04 AM
Replies: 43
Views: 1,620
Posted By CamaroCracka
This is exactly how YearOne got started....

This is exactly how YearOne got started. Manufacturers were selling of truckloads of their NOS parts, someone recognized the value and started a company based on it. Then they started making parts...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-25-2024, 05:19 AM
Replies: 33
Views: 1,218
Posted By CamaroCracka
Never ran them, but externally they look exactly...

Never ran them, but externally they look exactly like the 1LE axle. I have seen some info saying they run different CV joints than the 1LE, but I don't know that to be fact. They are supposed to be...
Forum: Tuning / Diagnostics -- engine and transmission 03-21-2024, 05:59 AM
Replies: 8
Views: 288
Posted By CamaroCracka
Guys on the HPTuners forum share tunes all the...

Guys on the HPTuners forum share tunes all the time, but if you are not a skilled tuner, I would not be using HPTuners on your own. You can buy an HPTuners device on many sites including Amazon or...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-21-2024, 05:25 AM
Replies: 34
Views: 1,153
Posted By CamaroCracka
True, but no more costly than CF and would never...

True, but no more costly than CF and would never break at my level. The added weight would be my biggest reason for sticking with a stock shaft.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-20-2024, 06:45 PM
Replies: 34
Views: 1,153
Posted By CamaroCracka
I feel like the stock shafts are stronger than...

I feel like the stock shafts are stronger than aluminum. If I ever do another one piece shaft it will be CF or chromoly.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-18-2024, 07:18 PM
Replies: 9
Views: 383
Posted By CamaroCracka
Never used heat wrap in the starter area. Did put...

Never used heat wrap in the starter area. Did put better grounding on the turbo car. It starts like a champ. No extra grounding on the vert and it's starter is lazy after initial startup. Will be...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 03-15-2024, 10:30 AM
Replies: 3
Views: 264
Posted By CamaroCracka
Thanks guys, I picked it up cheap and only want...

Thanks guys, I picked it up cheap and only want the exhaust pipes because I've removed the part between the clamps to where the pipes get close together on both my cars and would like a way back on...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 03-14-2024, 12:54 PM
Replies: 3
Views: 264
Posted By CamaroCracka
Sold

I picked up a full NPP exhaust today just to have for future use, but the diffusers on my cars are not for the dual tips. I know some guys need these, so if you are looking for the axle back portion,...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-14-2024, 08:13 AM
Replies: 33
Views: 1,218
Posted By CamaroCracka
And then they are hard to find replacements for. ...

And then they are hard to find replacements for.

On the axles, many have said being lowered puts a lot more stress on the CV. I'm only lowered half an inch in the rear, and when I broke a ZL1...
Forum: Forced Induction - V8 03-13-2024, 03:40 PM
Replies: 22
Views: 1,157
Posted By CamaroCracka
16° with E85. Not sure what gaskets the tuner...

16° with E85. Not sure what gaskets the tuner runs on the 5.3. It's SBE with aftermarket heads. His truck is race only and he already has a motor to go in it if it blows so he can afford to run 20+....
Forum: 5th Gen Camaro SS LS LT General Discussions 03-13-2024, 03:33 PM
Replies: 33
Views: 1,218
Posted By CamaroCracka
Driveshaft will be fine. Can't say for the axles...

Driveshaft will be fine. Can't say for the axles as I've never run stock axles with sticky tires.

I run roughly 800whp with slicks and a manual with a factory drive shaft.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 03-12-2024, 07:24 PM
Replies: 3
Views: 257
Posted By CamaroCracka
Not too long ago someone was able to get OEM Z28...

Not too long ago someone was able to get OEM Z28 axles but they were over $300 each. Z28 and 1LE axles were the best units for the 10 bolt. The outer CV is slightly larger than the regular SS axle. ...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-12-2024, 07:17 PM
Replies: 1
Views: 207
Posted By CamaroCracka
The only thing I have ever seen is the mount...

The only thing I have ever seen is the mount insert from RevShift and that is just for manuals.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 04:14 PM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.