The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Showing results 1 to 24 of 24
Search took 0.00 seconds. Search: Posts Made By: Cam 427
Forum: Camaro DIY & HOW-TO instructions & discussions 06-29-2011, 11:01 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
There is a good picture of one with the correct...

There is a good picture of one with the correct windshield near the front of this thread. A few pictures without the correct windshield throughout the thread.

Personally, I don't think the image...
Forum: Camaro DIY & HOW-TO instructions & discussions 04-28-2011, 12:46 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Agreed. One of the reasons I did mine.

Agreed. One of the reasons I did mine.
Forum: Camaro DIY & HOW-TO instructions & discussions 04-16-2011, 12:12 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I'd go with Patrick on this. I tried ordering...

I'd go with Patrick on this. I tried ordering through a dealer and it was delayed by GM so many times for no real reason. I finally canceled and ordered from Patrick. The kit had everything needed...
Forum: Camaro DIY & HOW-TO instructions & discussions 02-24-2011, 02:00 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I'm kind of wishing for this to happen to my...

I'm kind of wishing for this to happen to my windshield. The double image isn't bad, but not what it could be. I might just have to replace it someday.
Forum: Camaro DIY & HOW-TO instructions & discussions 02-07-2011, 09:57 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Ofer, you mentioned in one of these threads about...

Ofer, you mentioned in one of these threads about replacing your chipped windshield. Did you get it replaced with a HUD windshield yet ?
Forum: Camaro DIY & HOW-TO instructions & discussions 01-31-2011, 05:48 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
My steering wheel came right off , no puller was...

My steering wheel came right off , no puller was needed. I left the bolt in with a few threads and yanked on the wheel.
Forum: Camaro DIY & HOW-TO instructions & discussions 01-11-2011, 02:49 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Take a look at post 1343. The pictures look like...

Take a look at post 1343. The pictures look like production HUD installation. I looked a car at a dealer and that is what it looks like. Also, I took some measurements and measured 9 inches from the...
Forum: Camaro DIY & HOW-TO instructions & discussions 12-19-2010, 03:32 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I had this same problem.

I had this same problem.
Forum: Camaro DIY & HOW-TO instructions & discussions 12-17-2010, 10:49 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Did you get the two 13 mm bolts for the airbag...

Did you get the two 13 mm bolts for the airbag and the connector above the communcation module and battery? I would think that you've gotten these since you said it was loose. There are some small...
Forum: Camaro DIY & HOW-TO instructions & discussions 12-05-2010, 12:57 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Another succesful HUD install! A lot of work but...

Another succesful HUD install! A lot of work but not too bad. One person can do it but the dash is bulky and aukward to handle. For those of you that are planning to do this mod, remember to route...
Forum: Camaro DIY & HOW-TO instructions & discussions 11-30-2010, 02:14 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I agree... I would be nice to get a car without...

I agree... I would be nice to get a car without the stuff I will never use.
Forum: Camaro DIY & HOW-TO instructions & discussions 11-28-2010, 02:55 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Thanks. I've already started on this..hopefuly I...

Thanks. I've already started on this..hopefuly I will be done in a couple of days.
Forum: Camaro DIY & HOW-TO instructions & discussions 11-28-2010, 02:01 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
WCoolbreeze...what do you mean by "completely...

WCoolbreeze...what do you mean by "completely reset my car" ?
Thanks
Forum: Camaro DIY & HOW-TO instructions & discussions 11-22-2010, 01:17 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Looks like the two screws are located in the...

Looks like the two screws are located in the opening to the defroster duct (see previous page of the manual, 10-86). It maybe necessary to remove the defroster duct to access the screws. If that's...
Forum: Camaro DIY & HOW-TO instructions & discussions 11-18-2010, 07:10 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Did you get the trim piece too?

Did you get the trim piece too?
Forum: Camaro DIY & HOW-TO instructions & discussions 11-16-2010, 10:31 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I cancelled my order with my dealer and ordered...

I cancelled my order with my dealer and ordered from Patrick. Apparently the dealer couldn't go to Delphi direct for the hud and had no idea when he would get it.
Forum: Camaro DIY & HOW-TO instructions & discussions 11-16-2010, 08:39 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Payment sent.

Payment sent.
Forum: Camaro DIY & HOW-TO instructions & discussions 11-02-2010, 11:08 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
No ABL for me.

No ABL for me.
Forum: Camaro DIY & HOW-TO instructions & discussions 11-02-2010, 02:55 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Yeah ... Ordered my HUD parts about 2 weeks ago....

Yeah ... Ordered my HUD parts about 2 weeks ago. Just the switch so far.
Forum: Camaro DIY & HOW-TO instructions & discussions 10-24-2010, 01:58 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I don't like cutting up a component like many of...

I don't like cutting up a component like many of you, but for this mod I'm willing to. If I screw up with the cuts bad enough I'll go ahead and change the panel. As said above, I think this is an...
Forum: Camaro DIY & HOW-TO instructions & discussions 10-19-2010, 02:36 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Do you recall seeing any type of mounting points...

Do you recall seeing any type of mounting points for the HUD?
Forum: Camaro DIY & HOW-TO instructions & discussions 10-16-2010, 02:59 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
Thanks for your hard work in figuring this out....

Thanks for your hard work in figuring this out. American ingenuity at its best!
Please put me down for a harness.
Forum: Camaro DIY & HOW-TO instructions & discussions 08-04-2010, 10:57 AM
Replies: 1,993
Views: 515,416
Posted By Cam 427
How many harnesses are you making? Put me down...

How many harnesses are you making? Put me down for one.
Forum: Camaro DIY & HOW-TO instructions & discussions 07-27-2010, 05:47 PM
Replies: 1,993
Views: 515,416
Posted By Cam 427
I tried to order one through a local dealer and...

I tried to order one through a local dealer and they said any orders for the HUD would be cancelled by GM for now. No availability time line yet. So...we wait.
Showing results 1 to 24 of 24

 
Forum Jump

All times are GMT -5. The time now is 11:37 PM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.