The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Page 3 of 17 12 3 456713 Last »
Showing results 61 to 90 of 500
Search took 0.06 seconds; generated 102 minute(s) ago. Search: Posts Made By: CamaroCracka
Forum: Forced Induction - V8 06-09-2025, 07:51 AM
Replies: 3
Views: 846
Posted By CamaroCracka
I have 3.73s with a turbo and it smokes the tires...

I have 3.73s with a turbo and it smokes the tires in second on the street. Any more gearing would be useless. I run a 325/30/20 Sport Cup2 on the street. PD blower would be even worse for traction....
Forum: Suspension / Brakes / Chassis 06-06-2025, 06:51 AM
Replies: 14
Views: 1,576
Posted By CamaroCracka
For the track, Castrol SRF. Pricey, but works...

For the track, Castrol SRF. Pricey, but works great, even better than then Motul.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-03-2025, 09:50 AM
Replies: 4
Views: 545
Posted By CamaroCracka
Be Careful Using GMPartsGiant

I was trying to get a warranty replacement on a power steering pump I purchased from them online. In order to warranty the part, they require a diagnostic report from the dealer at my cost. Well,...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-24-2025, 06:53 AM
Replies: 5
Views: 1,560
Posted By CamaroCracka
You can run 305s all the way around with a ZL1...

You can run 305s all the way around with a ZL1 wheel. Have it on the vert. I think the 285 square setup with stock 9" wheels has been done, but I've never tried it myself.



I contacted...
Forum: Suspension / Brakes / Chassis 05-21-2025, 08:09 PM
Replies: 1
Views: 780
Posted By CamaroCracka
You can definitely drop the cradle down a few...

You can definitely drop the cradle down a few inches without disconnecting. The first time I did cradle bushings, I completely removed the cradle, but I don't remember if I unhooked the connector...
Forum: Suspension / Brakes / Chassis 05-21-2025, 08:03 PM
Replies: 29
Views: 2,588
Posted By CamaroCracka
Perhaps, the vert is a 2011 and the turbo car is...

Perhaps, the vert is a 2011 and the turbo car is a 2010.
Forum: Suspension / Brakes / Chassis 05-21-2025, 08:27 AM
Replies: 29
Views: 2,588
Posted By CamaroCracka
The 1LE, ZL1 and Z28 bars are all supposed to be...

The 1LE, ZL1 and Z28 bars are all supposed to be solid. I have seen many people say the SS bars are solid, but I cut apart a front and rear bar from my vert and they were both hollow.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 05-21-2025, 07:44 AM
Replies: 17
Views: 1,181
Posted By CamaroCracka
DSS had historically done pretty good by...

DSS had historically done pretty good by customers even after warranty expires. Hope they fix your stuff.
Forum: Suspension / Brakes / Chassis 05-18-2025, 11:37 AM
Replies: 29
Views: 2,588
Posted By CamaroCracka
1LE bars are 27/28. ZL1 25/28. Both the 1LE and...

1LE bars are 27/28. ZL1 25/28. Both the 1LE and the ZL1 use the same rear bar. Z28 are only 25/26.
Forum: Suspension / Brakes / Chassis 05-18-2025, 09:49 AM
Replies: 29
Views: 2,588
Posted By CamaroCracka
I got my Z28 setup from an SCCA racer who helped...

I got my Z28 setup from an SCCA racer who helped develop the DSSVs on the Gen5 with GM and GM had him move the mounts on the front shocks down 1 inch and only a half in inch in the back. He said the...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2025, 09:31 AM
Replies: 2
Views: 363
Posted By CamaroCracka
Most parts are discontinued these days, but...

Most parts are discontinued these days, but people are still parting out cars. I've seen full convertible tops in good condition for about 1000USD.

Hawks Performance and AZ Cycle Parts are two...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-15-2025, 10:03 AM
Replies: 5
Views: 1,560
Posted By CamaroCracka
SS and 1LE/SS never came with Magnaride in Gen5....

SS and 1LE/SS never came with Magnaride in Gen5. 1LE had monotube shocks that were better than plain SS shocks. I'm not sure anyone has gotten Magnaride to work on an SS and you would not want to at...
Forum: ZL1 Parts 05-13-2025, 06:51 PM
Replies: 5
Views: 1,183
Posted By CamaroCracka
Great price, someone should jump on that. ...

Great price, someone should jump on that.

Got me thinking of getting it as a spare and selling the mag ride shocks to recover some of the cost.
Forum: Camaro DIY & HOW-TO instructions & discussions 05-13-2025, 06:48 PM
Replies: 2
Views: 1,013
Posted By CamaroCracka
I have a Braum harness bar which looks identical,...

I have a Braum harness bar which looks identical, and I don't have an inch of play. If there is too much play, I would guess the heim joints are not tightened properly.
Forum: Wheels / Tires 05-05-2025, 02:43 PM
Replies: 6
Views: 961
Posted By CamaroCracka
They have a little life left in them, but some...

They have a little life left in them, but some shops don't like to touch used tires. I don't get to drive the toys as much as I like so the track tires age out before they wear out. I saw a tool...
Forum: Suspension / Brakes / Chassis 04-30-2025, 03:55 PM
Replies: 12
Views: 9,175
Posted By CamaroCracka
Correct, Gen5 ZL1 hats are larger than Gen5...

Correct, Gen5 ZL1 hats are larger than Gen5 Z28/Gen6. The small diameter of the Gen6 hat is what allows for the significant increase in swept area over the Gen5-ZL1

FYI, Gen6 Zl1 calipers are the...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-29-2025, 11:03 AM
Replies: 9
Views: 6,111
Posted By CamaroCracka
Guy has two listed on Facebook group for $1300...

Guy has two listed on Facebook group for $1300 ea. Agree, $2500 is steep for a diff.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-27-2025, 11:45 AM
Replies: 9
Views: 4,750
Posted By CamaroCracka
Your only going to get a couple inches before the...

Your only going to get a couple inches before the trans hits the tunnel. The rad hoses will flex that much. I did the 2x4 under the pan method when I went to urethane motor mounts. Not sure on the...
Forum: Suspension / Brakes / Chassis 04-27-2025, 11:31 AM
Replies: 9
Views: 6,909
Posted By CamaroCracka
You need the GM FE4 LCA or it's aftermarket...

You need the GM FE4 LCA or it's aftermarket equivalent. You could modify and FE3 LCA to accept the FE4 sway bar links, but when I did both of mine the FE4 LCAs were around $50. You can also find them...
Forum: Suspension / Brakes / Chassis 04-27-2025, 11:27 AM
Replies: 1
Views: 1,077
Posted By CamaroCracka
Steering Shudder Appears Fixed

I blew the return power steering line at Sebring and ever since I had a bit of a steering shudder. Thanks to J35Y2, when he mentioned that he his car acted like it was having a seizure when it had...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2025, 06:40 AM
Replies: 10
Views: 5,843
Posted By CamaroCracka
Sorry, they are 10.9. I still refer to that stuff...

Sorry, they are 10.9. I still refer to that stuff as grade 5 and 8.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-16-2025, 06:19 AM
Replies: 6
Views: 4,643
Posted By CamaroCracka
If you have any welding experience at all, it's...

If you have any welding experience at all, it's actually a pretty easy mod. The hardest part is you can't really get a good view of the top with the engine in, but you can get a good weld on the...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2025, 06:06 AM
Replies: 20
Views: 9,343
Posted By CamaroCracka
Thanks for the info.

Thanks for the info.
Forum: Forced Induction - V8 04-15-2025, 03:44 PM
Replies: 6
Views: 5,977
Posted By CamaroCracka
If you are putting in pistons, why not put in...

If you are putting in pistons, why not put in rods too? Stock crank with forged pistons and rods is good to 1000. I align bored my block and put in main studs just to be on the safe side.

1000...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-15-2025, 08:32 AM
Replies: 0
Views: 1,546
Posted By CamaroCracka
Radiator Power Steering Cooler Provision

Disregard, I figured out it's part of the condenser assembly.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-14-2025, 08:21 PM
Replies: 6
Views: 4,643
Posted By CamaroCracka
The oil pump installs over the crank, so while...

The oil pump installs over the crank, so while you might be able to finagle the pick up off, you will never get the pump off without removing the timing cover.

Also, the pan won't come down with...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-14-2025, 08:13 PM
Replies: 11
Views: 2,558
Posted By CamaroCracka
Not sure on the fuel pump part numbers, but I'm...

Not sure on the fuel pump part numbers, but I'm pretty sure fuel pressure should be 58psi all the time, more if you are boosted.

Why not just get a ZL1 pump and call it a day. They work great.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-14-2025, 08:08 PM
Replies: 5
Views: 7,238
Posted By CamaroCracka
Kind of, I once bought an entire Z28 suspension,...

Kind of, I once bought an entire Z28 suspension, and it had an electric steering rack, so I've seen how they are mounted and the difference between them and a hydraulic rack while I was disassembling...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-13-2025, 07:32 AM
Replies: 5
Views: 7,238
Posted By CamaroCracka
I don't have EPS, but it's definitely easier to...

I don't have EPS, but it's definitely easier to get the rack out if you disconnect the sway bar on the driver's side.
Forum: Suspension / Brakes / Chassis 04-13-2025, 07:27 AM
Replies: 9
Views: 6,909
Posted By CamaroCracka
I would just go FE4. Much better setup. The bar...

I would just go FE4. Much better setup. The bar you have looks like it might get you into fitment problems when you go to put it in and it will never work as well as the FE4 bar.

On the links, I...
Showing results 61 to 90 of 500
Page 3 of 17 12 3 456713 Last »

 
Forum Jump

All times are GMT -5. The time now is 08:03 PM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.