The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Page 1 of 5 1 2345
Showing results 1 to 30 of 134
Search took 0.01 seconds. Search: Posts Made By: tlamb2
Forum: Forced Induction - V8 10-29-2025, 02:29 PM
Replies: 6
Views: 147
Posted By tlamb2
FasNuf, I will get a copy of the tune from the...

FasNuf, I will get a copy of the tune from the tuner and send it to you when I get it. It will be a week till I get out there. Thanks for your input. It was funny when I was reading your reply; I was...
Forum: Forced Induction - V8 10-29-2025, 07:58 AM
Replies: 6
Views: 147
Posted By tlamb2
You would think the tuners would see it right?...

You would think the tuners would see it right? Now, when I move them up, will it mess with the tune?
Forum: Forced Induction - V8 10-29-2025, 06:37 AM
Replies: 6
Views: 147
Posted By tlamb2
Upstream 02 sensor after cats?

So I threw a P0134 Code. 02 sensor bank one sensor 1. So I picked up an Upstream 02 sensor, and when I went to replace it, the downstream sensor was in the Header bung, and the upstream was behind...
Forum: Forced Induction - V8 08-05-2024, 10:44 PM
Replies: 5
Views: 4,353
Posted By tlamb2
Ok thanks for the input

Ok thanks for the input
Forum: Forced Induction - V8 08-03-2024, 02:37 AM
Replies: 5
Views: 4,353
Posted By tlamb2
Looking for some advice on next upgrade

So I went to the casino last night and sat down and 3rd spin hit for 10k. So it is time for an upgrade. My car is 2010SS with a Maggie, Meth, Cam. I have done all the suspension with AfE coil-overs...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-31-2024, 04:54 AM
Replies: 22
Views: 4,392
Posted By tlamb2
I had the G8 kit and the fluid always ended up...

I had the G8 kit and the fluid always ended up boiling on hot days and the next day I would have to bleed the clutch from the air in the lines. It was because the reservoir was so small and if you...
Forum: Forced Induction - V8 12-10-2023, 05:09 AM
Replies: 13
Views: 3,821
Posted By tlamb2
Ok thanks for the info, I will give you guys a...

Ok thanks for the info, I will give you guys a call
Forum: Forced Induction - V8 12-09-2023, 01:26 AM
Replies: 13
Views: 3,821
Posted By tlamb2
So the car has a 3.3 pully right now with your...

So the car has a 3.3 pully right now with your FPCM and a ZL1 fuel pump. I have a JMS BAP I will be installing also. Will that be ok for fuel demands? The car is running the injectors that came with...
Forum: Forced Induction - V8 11-30-2023, 12:10 PM
Replies: 2
Views: 1,454
Posted By tlamb2
If you are not using NPT hoses and using push to...

If you are not using NPT hoses and using push to connect lines those will leak like crazy. Mine drove me crazy until I got all new lines that you tighten with a wrench problem solved for me. I had to...
Forum: Forced Induction - V8 11-07-2023, 01:07 AM
Replies: 13
Views: 3,821
Posted By tlamb2
Did you go with new lifters? or how about a...

Did you go with new lifters? or how about a trunion kit? I am getting ready to order and trying to decide what I need. Any advice
Forum: Forced Induction - V8 11-05-2023, 01:38 AM
Replies: 13
Views: 3,821
Posted By tlamb2
I use to run an ACT clutch and it was junk. I got...

I use to run an ACT clutch and it was junk. I got the Monster and never looked back
Forum: Forced Induction - V8 11-03-2023, 08:27 PM
Replies: 13
Views: 3,821
Posted By tlamb2
Yes, I was thinking that cause I do not spend...

Yes, I was thinking that cause I do not spend much time at 6k RPM most is in the mid-range. Thanks
Forum: Forced Induction - V8 11-03-2023, 08:03 PM
Replies: 13
Views: 3,821
Posted By tlamb2
I need a little advice on a cam

My car is a 2010 Camaro SS with a Maggie, Meth, CAI, ARH headers. I am looking for a cam for the car I was looking at the Brian Tooley PDS stage 2 or stage 3 torque supercharger camshaft. The guy...
Forum: Forced Induction - V8 01-04-2023, 08:52 AM
Replies: 8
Views: 1,609
Posted By tlamb2
Just an update I sent the pics to Magnuson and...

Just an update I sent the pics to Magnuson and they replied saying the coating is still there but he suggested stopping spraying before the intake. I have read that the meth is completely vaporized...
Forum: Forced Induction - V8 01-04-2023, 03:28 AM
Replies: 8
Views: 1,609
Posted By tlamb2
Used a borescope to get pics inside Maggie

What seemed most alarming is the scorn to the inside of the blower or is this normal? The coating seems to be fine tell me your opinion

1117446

1117447

1117449
Forum: Forced Induction - V8 01-02-2023, 02:25 AM
Replies: 8
Views: 1,609
Posted By tlamb2
Yes not into removing the lid and I thought...

Yes not into removing the lid and I thought Stevieturbo was talking about the boost drop thanks for your input
Forum: Forced Induction - V8 01-01-2023, 04:50 AM
Replies: 8
Views: 1,609
Posted By tlamb2
I don't have a boost gauge

I don't have a boost gauge
Forum: Forced Induction - V8 12-31-2022, 02:35 AM
Replies: 8
Views: 1,609
Posted By tlamb2
Spraying 100% meth and damaging coating on Maggie?

So I have a 2010 Camaro SS with 50,000 miles. And have been spraying 100% meth right before the TB since about 10k miles. Does 100% meth damage the coating on the rotars? I was speaking to a lady at...
Forum: Suspension / Brakes / Chassis 06-18-2022, 10:11 PM
Replies: 17
Views: 5,721
Posted By tlamb2
Mine is not my DD either so I can take the...

Mine is not my DD either so I can take the trade-off for a performance suspension. The Diff bushings and upper Control arm bushings make a huge difference. I already had the solid subframe bushings...
Forum: Suspension / Brakes / Chassis 06-14-2022, 07:45 PM
Replies: 17
Views: 5,721
Posted By tlamb2
https://www.camaro5.com/forums/showthread.php?t=44...

https://www.camaro5.com/forums/showthread.php?t=442053&highlight=Hendrix This thread addresses the noise issue it is bad
Forum: Suspension / Brakes / Chassis 06-11-2022, 04:05 AM
Replies: 17
Views: 5,721
Posted By tlamb2
Nice job I just did the exact same thing except I...

Nice job I just did the exact same thing except I already had solid subframe bushings and toe ends and trailing arms. I did aFe Featherlight coilovers, Hotchkiss sways with the 2012 outside mounting...
Forum: Forced Induction - V8 05-17-2022, 01:10 AM
Replies: 9
Views: 1,706
Posted By tlamb2
Cat check

I am gonna get under the car and look thru the cutouts to see what shape they are in. The car only has 50k miles but Maggie is on it for 40K miles. And I have a ranch in Arizona and no smog in the...
Forum: Forced Induction - V8 05-13-2022, 07:52 PM
Replies: 9
Views: 1,706
Posted By tlamb2
I am running 9 PSI and I have boost activated...

I am running 9 PSI and I have boost activated cutouts right behind the cats. And I am running ARH headers and high-flow cats. What I have read is that ARH stuff is better than most other cats.
Forum: Forced Induction - V8 05-13-2022, 01:47 AM
Replies: 9
Views: 1,706
Posted By tlamb2
Ok I am gonna gut them, does it need to be tuned...

Ok I am gonna gut them, does it need to be tuned after you gut them? And is the smell that bad? and the engine runs cooler right
Forum: Forced Induction - V8 05-11-2022, 06:31 PM
Replies: 9
Views: 1,706
Posted By tlamb2
Maggie running high flow cats

The car is registered in Arizona with no smog check and 5-year sticker. Should I ditch the cats? or keep them on what are the pros and cons thanks
Forum: Suspension / Brakes / Chassis 05-06-2022, 06:45 PM
Replies: 17
Views: 5,721
Posted By tlamb2
These guys are the best

http://www.accuratealignments.com/ in Oceanside
Forum: Suspension / Brakes / Chassis 04-17-2022, 01:16 AM
Replies: 2
Views: 1,087
Posted By tlamb2
How big is your clutch reservoir? The one I was...

How big is your clutch reservoir? The one I was using was only like 2oz and my fluid still boiled when driving long distances in the heat. So I switched to the 16oz aluminum one now my fluid stays...
Forum: Suspension / Brakes / Chassis 01-12-2022, 12:03 AM
Replies: 1
Views: 1,352
Posted By tlamb2
Suspension questions

So I am upgrading my 2010 SS Camaro suspension. I have already done solid sub-frame bushings, rear toe rod, Trailing arms, and have Eibach pro kit springs and sways. I have Afe coilovers being...
Forum: Suspension / Brakes / Chassis 01-04-2022, 01:25 AM
Replies: 16
Views: 3,409
Posted By tlamb2
I have found the rears and the front left...

I have found the rears and the front left Bilsteins just need the front passenger think I found one from Bilstein in UK It is a lil more $ but better than waiting 3 months
Forum: Suspension / Brakes / Chassis 01-03-2022, 02:26 AM
Replies: 16
Views: 3,409
Posted By tlamb2
The coilovers arrived and they were not as...

The coilovers arrived and they were not as described actually one had this janky weld on it. So I opened a return claim and eBay sided with me. They are returning my $ and shipping. The guy who sold...
Showing results 1 to 30 of 134
Page 1 of 5 1 2345

 
Forum Jump

All times are GMT -5. The time now is 01:44 AM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.