Chevrolet Corvette Stingray C7 Forum

		Chevrolet Corvette Stingray C7 Forum > Search Forums
Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Soyuz100

Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls

02-01-2018, 07:52 PM

Replies: 21

Key stuck in ignition, not getting into "P" gear properly

Views: 13,991

Posted By Soyuz100

This problem is most likely caused by the shifter...

This problem is most likely caused by the shifter linkage being set "too tight". I am putting the 6L80E into my truck, using the stock Camaro floor shifter. When I set the linkage too tight, the...

Forum: General Automotive + Other Cars Discussion

10-11-2017, 07:05 PM

Replies: 3

L99 in 1962 C20

Views: 3,116

Posted By Soyuz100

Rear end and engine angles are now set so the...

Rear end and engine angles are now set so the driveshaft U-joint angles are ~2 degrees. The next phase is getting the frame notched to fit the exhaust manifolds, AC compressor and alternator. Here is...

Forum: General Automotive + Other Cars Discussion

10-05-2017, 07:31 PM

Replies: 3

L99 in 1962 C20

Views: 3,116

Posted By Soyuz100

L99 in 1962 C20

Picked up a rough '62 C20 that needed a lot of rust repair. Since I was taking everything apart, might as well upgrade the engine. Currently in the process of getting the 2010 Camaro engine / trans...

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -5. The time now is 08:12 PM.