The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.04 seconds. Search: Posts Made By: larry_g
Forum: 5th Gen Camaro SS LS LT General Discussions 12-31-2025, 07:16 AM
Replies: 12
Views: 235
Posted By larry_g
Thanks for your continued commitment here. Even...

Thanks for your continued commitment here. Even those that don't post a lot appreciate the knowledge and experience that you share.


Sent from my Pixel 8 Pro using Tapatalk
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-25-2025, 10:07 AM
Replies: 3
Views: 166
Posted By larry_g
I kept the FPCM in place and used the power...

I kept the FPCM in place and used the power output for my fuel pump relays. This allows the pump to prime with turning the key on. But more importantly it keeps the safeties in place that cut power...
Forum: Forced Induction - V8 12-17-2025, 08:36 AM
Replies: 26
Views: 552
Posted By larry_g
Also, I highly recommend going flex fuel for 93...

Also, I highly recommend going flex fuel for 93 and E85, boosted engines really like E85.

Sent from my Pixel 8 Pro using Tapatalk
Forum: Forced Induction - V8 12-17-2025, 08:33 AM
Replies: 26
Views: 552
Posted By larry_g
Definitely try to get the "while you're at it"...

Definitely try to get the "while you're at it" done at the same time. The only problem is every time you want more, it's another tune...

In my case with the throttle body, I didn't hit the number...
Forum: Forced Induction - V8 12-16-2025, 07:01 PM
Replies: 26
Views: 552
Posted By larry_g
FWIW, I didn't benefit from the larger throttle...

FWIW, I didn't benefit from the larger throttle body until I was well over 700 whp. I had a stock LS3 TB that I ported myself up until that time.



Sent from my Pixel 8 Pro using Tapatalk
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 12-09-2025, 07:10 AM
Replies: 2
Views: 403
Posted By larry_g
Different wheel width or offset front to rear?...

Different wheel width or offset front to rear? Could have a rear wheel on the front.


Sent from my Pixel 8 Pro using Tapatalk
Forum: 5th Gen Camaro SS LS LT General Discussions 10-14-2025, 07:03 AM
Replies: 3
Views: 413
Posted By larry_g
Is there powder coat over spray on any of the...

Is there powder coat over spray on any of the mating surfaces? You'll probably need more than scotch brite to get it off but you need to make sure those surfaces are clean and flat.

You can use...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-29-2025, 07:27 AM
Replies: 6
Views: 608
Posted By larry_g
First thing I'd look at is the MAF, make sure...

First thing I'd look at is the MAF, make sure it's the right one in the correct position and plugged in completely. I would also check any other sensor you touched. There's no pending or permanent...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-04-2025, 07:47 AM
Replies: 5
Views: 1,633
Posted By larry_g
Nope. It's still mostly metal under there. By the...

Nope. It's still mostly metal under there. By the time you get to the open area the angle is all wrong.



Sent from my Pixel 8 Pro using Tapatalk
Forum: Camaro 1LE Forum 08-25-2025, 07:04 AM
Replies: 4
Views: 1,731
Posted By larry_g
I was getting ready to go supercharged when I...

I was getting ready to go supercharged when I found the crack in my sleeve. I ended up finding a slightly used LSA block and used that for my build. Not sure what's available out there used, but it...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-22-2025, 07:02 AM
Replies: 2
Views: 961
Posted By larry_g
There's a slip joint to set the length, just bolt...

There's a slip joint to set the length, just bolt in one end and pull on the other.

Sent from my Pixel 8 Pro using Tapatalk
Forum: Forced Induction - V8 08-20-2025, 07:02 AM
Replies: 23
Views: 2,740
Posted By larry_g
Thanks for the update and congrats on getting it...

Thanks for the update and congrats on getting it working. Now go enjoy it!

Sent from my Pixel 8 Pro using Tapatalk
Forum: Forced Induction - V8 07-31-2025, 04:52 PM
Replies: 23
Views: 2,740
Posted By larry_g
Sounds to me that they tried to tune around the...

Sounds to me that they tried to tune around the problem instead of actually having to figure out why it wasn't working. Time to get back to basics and make sure you have good grounds, proper...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-25-2025, 12:56 PM
Replies: 4
Views: 416
Posted By larry_g
Nick Williams makes a 103 for boosted...

Nick Williams makes a 103 for boosted applications, just make sure you are buying a legit one from a reputable source. Whipple makes an adapter and gaskets for the larger throttle body, you can order...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-24-2025, 07:32 AM
Replies: 9
Views: 742
Posted By larry_g
I'd still suggest touching every connector to...

I'd still suggest touching every connector to make sure they're seated properly and visually confirm nothing is pinched or pulled too tight. I would then get some data logs and see if the tuner can...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-23-2025, 02:53 PM
Replies: 9
Views: 742
Posted By larry_g
Time to double check all connections. It's...

Time to double check all connections. It's possible the meltdown did some additional unseen damage (PCM) but it seems strange that it only happens under heavy load. Perhaps something is rubbing or...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-23-2025, 06:48 AM
Replies: 9
Views: 742
Posted By larry_g
Why the new wiring harness? Sent from...

Why the new wiring harness?



Sent from my Pixel 8 Pro using Tapatalk
Forum: Forced Induction - V8 06-21-2025, 09:07 AM
Replies: 3
Views: 765
Posted By larry_g
I'm not positive about SLP but I don't recall any...

I'm not positive about SLP but I don't recall any permanent mods required for my Whipple. Most kits are true bolt-ons. Anything worth modifying is usually replaced.

You might want to see if you...
Forum: Forced Induction - V8 06-21-2025, 08:59 AM
Replies: 68
Views: 144,467
Posted By larry_g
Way to resurrect a dead thread. It all depends on...

Way to resurrect a dead thread. It all depends on what your goals are, personally I went with a Monster triple because I knew I would want more power eventually and it has served me well so far.
...
Forum: Forced Induction - V8 06-20-2025, 06:52 AM
Replies: 3
Views: 765
Posted By larry_g
It really depends on if you have any of the...

It really depends on if you have any of the original stock parts available and what supporting mods were done with it. For example, were the injectors also replaced. You'll also need a fresh tune to...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-13-2025, 06:59 AM
Replies: 6
Views: 868
Posted By larry_g
So I guess the real question is do you even need...

So I guess the real question is do you even need the vent in the valve cover or are you handling it elsewhere. I know when I was doing my build I bought a set of tall valve covers that looked like...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-12-2025, 06:52 AM
Replies: 6
Views: 868
Posted By larry_g
Also curious what rockers you are running as I...

Also curious what rockers you are running as I have the Yella Terra and they fit under the Holley tall covers without the extra thick gasket.

Sent from my Pixel 8 Pro using Tapatalk
Forum: Forced Induction - V8 06-09-2025, 07:01 AM
Replies: 3
Views: 785
Posted By larry_g
I'm not positive, but I'm going to guess it has...

I'm not positive, but I'm going to guess it has to do with available traction. My car has 3.91 stock and I can tell you first and second gears are just about useless with street tires.

Sent from...
Forum: Off-topic Discussions 06-07-2025, 09:27 AM
Replies: 17
Views: 4,958
Posted By larry_g
I mean, I wouldn't throw it out of my garage, but...

I mean, I wouldn't throw it out of my garage, but it's probably not where I would spend my money either.


Sent from my Pixel 8 Pro using Tapatalk
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-04-2025, 06:54 AM
Replies: 6
Views: 945
Posted By larry_g
I've heard in the past that a sulphur smell is...

I've heard in the past that a sulphur smell is common when a cat goes bad. Interesting that you just passed a smog check.



Sent from my Pixel 8 Pro using Tapatalk
Forum: Tuning / Diagnostics -- engine and transmission 06-02-2025, 07:10 AM
Replies: 8
Views: 1,008
Posted By larry_g
Good news Sent from my Pixel 8 Pro using...

Good news

Sent from my Pixel 8 Pro using Tapatalk
Forum: Tuning / Diagnostics -- engine and transmission 06-01-2025, 07:52 AM
Replies: 8
Views: 1,008
Posted By larry_g
Did you replace the FPCM or is it setup in the...

Did you replace the FPCM or is it setup in the tune?

Sent from my Pixel 8 Pro using Tapatalk
Forum: 5th Gen Camaro SS LS LT General Discussions 05-24-2025, 09:06 AM
Replies: 11
Views: 515
Posted By larry_g
Also, I would think the pipe from cylinder #3...

Also, I would think the pipe from cylinder #3 going up and over is unusual and would indicate a particular brand. My stainless works headers don't do that and I don't recall seeing others with that...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-21-2025, 06:41 AM
Replies: 24
Views: 1,292
Posted By larry_g
Depending on the clamps used, you could have a...

Depending on the clamps used, you could have a small exhaust leak that doesn't sound noticable but will smell in the interior.

Sent from my Pixel 8 Pro using Tapatalk
Forum: 5th Gen Camaro SS LS LT General Discussions 05-10-2025, 11:43 AM
Replies: 27
Views: 1,349
Posted By larry_g
I had a real issue with oil transfer to my catch...

I had a real issue with oil transfer to my catch can with these valve covers but it was due to the amount of vacuum my Whipple was generating. I ended up purchasing and working with Mighty Mouse...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 10:43 AM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.