The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Page 1 of 7 1 2345 Last »
Showing results 1 to 30 of 208
Search took 0.02 seconds. Search: Posts Made By: jlaudio11
Forum: ZL1 Discussions 06-03-2024, 11:35 PM
Replies: 41
Views: 1,367
Posted By jlaudio11
A few bucks can be saved on the low side aux kit...

A few bucks can be saved on the low side aux kit by doing your own lines and pump setup controlling it with the THP reflex plus controller like I did. No need for a separate control method.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-30-2024, 11:24 AM
Replies: 6
Views: 475
Posted By jlaudio11
If you're willing and wanting to do all that, I...

If you're willing and wanting to do all that, I would step back and look at the car as a whole. Are you trying to run in a specific class or just trying to run as fast as possible? Moving the...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-29-2024, 04:46 PM
Replies: 6
Views: 475
Posted By jlaudio11
A local guy did it on a crank driven procharged...

A local guy did it on a crank driven procharged GTO but he had to cut the trunk out to fit. The space where the factory airbox used to be I would think would fit a decent size turbo. Routing...
Forum: Forced Induction Discussions 05-29-2024, 04:30 PM
Replies: 6
Views: 254
Posted By jlaudio11
Yea it wasn't something they advertised as much...

Yea it wasn't something they advertised as much because most people run a blower but researching it, it was a really simple to set up with a mac valve and works well. If you're not looking for crazy...
Forum: Forced Induction Discussions 05-29-2024, 09:03 AM
Replies: 6
Views: 254
Posted By jlaudio11
Boost controllers like anything can be simple or...

Boost controllers like anything can be simple or rather sophisticated. If you are adding port injection, the toohighpsi port controller's built in boost controller works decent using boost pressure...
Forum: Forced Induction Discussions 05-20-2024, 04:25 PM
Replies: 15
Views: 631
Posted By jlaudio11
Nitrous is good for making power. Not that great...

Nitrous is good for making power. Not that great at absorbing heat to cool intake charge. If you’re trying to make x amount of power without spinning the blower to a point it’s just pumping heat it...
Forum: Dragstrip and Launching Discussion 05-17-2024, 09:58 AM
Replies: 9
Views: 411
Posted By jlaudio11
I went bias ply to be easier on the drivetrain in...

I went bias ply to be easier on the drivetrain in general. I also run alot of daily driver classes that require a dot tire. That’s how I ended up with the quick time pros, they’re popular in the no...
Forum: Dragstrip and Launching Discussion 05-16-2024, 07:48 AM
Replies: 9
Views: 411
Posted By jlaudio11
18157http://https://www.summitracing.com/parts/hoo...

18157http://https://www.summitracing.com/parts/hoo-18157

http://https://www.summitracing.com/parts/mnh-mhr-173

http://https://www.summitracing.com/parts/phx-ph187
Forum: Dragstrip and Launching Discussion 05-15-2024, 07:39 PM
Replies: 9
Views: 411
Posted By jlaudio11
I’ve had decent results with the Hoosier quick...

I’ve had decent results with the Hoosier quick time pro bias ply. It is a soft sidewall tire. If you’re not running a class requiring a dot tire I would probably go with a Hoosier c07 stiff...
Forum: Tuning / Diagnostics 05-15-2024, 07:16 PM
Replies: 15
Views: 444
Posted By jlaudio11
If it failed to process flash data you don’t have...

If it failed to process flash data you don’t have the necessary internet connection. Even after you change the tune on the tcm, it will always show a stock calibration if you read the file back out.
Forum: Tuning / Diagnostics 05-10-2024, 10:34 PM
Replies: 15
Views: 444
Posted By jlaudio11
That is the process. Are you on the latest beta?

That is the process. Are you on the latest beta?
Forum: Tuning / Diagnostics 05-10-2024, 09:19 PM
Replies: 15
Views: 444
Posted By jlaudio11
There is a process in vcm scanner to replace a...

There is a process in vcm scanner to replace a tcm. Don’t remember the specifics but you might want to look into that.
Forum: Suspension | Brakes | Chassis 05-08-2024, 04:55 PM
Replies: 2
Views: 304
Posted By jlaudio11
If it’s a bracket car I would skip all the...

If it’s a bracket car I would skip all the suspension stuff, do the bolt ons you’re talking about and put the car on a bias ply tire. My time is in my signature and that’s on all stock parts with a...
Forum: Suspension | Brakes | Chassis 05-08-2024, 10:07 AM
Replies: 2
Views: 319
Posted By jlaudio11
I had my car aligned for drag racing with as...

I had my car aligned for drag racing with as little camber as I could get on the stock parts and with just a little bit of toe in. It definitely helped launching.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-29-2024, 10:36 AM
Replies: 58
Views: 5,127
Posted By jlaudio11
The tcm can be unlocked and you still wouldn’t...

The tcm can be unlocked and you still wouldn’t see the tune in it. It’s part of how hptuners is fooling the rest of the system that the tcm is still stock. It will always show stock calibration...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-26-2024, 09:17 PM
Replies: 58
Views: 5,127
Posted By jlaudio11
Atleast you have the right attitude about it all....

Atleast you have the right attitude about it all. With launching, what worked the best for me and what you saw in those videos was holding rpms up around 900-1000 rpm and then smashing it. You’ll...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-26-2024, 03:38 PM
Replies: 58
Views: 5,127
Posted By jlaudio11
I know the btr cam is going to lose a little...

I know the btr cam is going to lose a little torque down low from a stock cam but it kind of seems like torque management is still limiting torque on the initial hit, shift rpm does seem low as well....
Forum: Dragstrip and Launching Discussion 04-16-2024, 05:16 PM
Replies: 29
Views: 2,132
Posted By jlaudio11
I'm pretty sure he's saying to lower timing in...

I'm pretty sure he's saying to lower timing in the sub 5000/4500 rpm range to make less torque and to get the car to go down the track. Once it shifts it'll never be that low again to hurt you the...
Forum: Dragstrip and Launching Discussion 04-16-2024, 05:14 PM
Replies: 29
Views: 2,132
Posted By jlaudio11
Congrats!! Ironic I went to the track as well...

Congrats!! Ironic I went to the track as well but it didn't go so well. Track got reground but they couldn't get rubber down with rain most of the week so they called it a no prep and I spun the...
Forum: Dragstrip and Launching Discussion 04-10-2024, 11:22 AM
Replies: 29
Views: 2,132
Posted By jlaudio11
Yea it’s shift scheduling in the tcm tune. My...

Yea it’s shift scheduling in the tcm tune. My car currently has a 3rd gear launch tune in manual mode in it. I’ll have a 2nd gear launch in manual mode the next time I go to the track. I’m...
Forum: Dragstrip and Launching Discussion 04-10-2024, 09:02 AM
Replies: 29
Views: 2,132
Posted By jlaudio11
Definitely not. My 9.28 was launching in 1st...

Definitely not. My 9.28 was launching in 1st gear with a 10 spd. I’ve used 2nd and 3rd gear launches on no prep/back of the track. I’ve exhausted that and moving to 2nd gear launch on front side...
Forum: Dragstrip and Launching Discussion 04-10-2024, 08:51 AM
Replies: 29
Views: 2,132
Posted By jlaudio11
Really? I was doing a burnout in 1st and...

Really? I was doing a burnout in 1st and shifting to second. Loading up 2nd from the hit and staying in 2nd has been fine for me. 3rd seems like a lot of wheel speed to suddenly stop when it bites...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-09-2024, 06:59 PM
Replies: 11
Views: 663
Posted By jlaudio11
Maintaining the stock camshaft maintains the...

Maintaining the stock camshaft maintains the majority of the engines power profile, intake manifold plays into this a little bit. A tune for your setup should be able to achieve max power without...
Forum: Dragstrip and Launching Discussion 04-09-2024, 08:11 AM
Replies: 16
Views: 1,164
Posted By jlaudio11
Do you have any pics of your bolt in cage...

Do you have any pics of your bolt in cage installed? How invasive was it?
Forum: Tuning / Diagnostics 04-02-2024, 07:16 PM
Replies: 9
Views: 710
Posted By jlaudio11
The license is tied to the device that tunes the...

The license is tied to the device that tunes the vehicle. You paid for this when you originally had it tuned. A new device tuning it will require new license. It isn’t every time a tune is written...
Forum: Tuning / Diagnostics 04-02-2024, 05:36 PM
Replies: 9
Views: 710
Posted By jlaudio11
Changing the table that sets that "30%" isn't...

Changing the table that sets that "30%" isn't going to increase fuel economy, it's just going to adjust how fast or slow you get there. Variable cam timing and how soon the engine gets into...
Forum: Forced Induction Discussions 03-26-2024, 10:08 AM
Replies: 3
Views: 997
Posted By jlaudio11
There are layers to it. You need to understand...

There are layers to it. You need to understand how to use nitrous, like you generally want to be above 3000 rpm before spraying a substantial shot. The massive torque spike before this can break...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 03-08-2024, 03:53 PM
Replies: 24
Views: 1,270
Posted By jlaudio11
I'm all for car names. My Garnett Red Camaro...

I'm all for car names.
My Garnett Red Camaro is Rooster
My quick Ecoboost F150 is Doc Holiday
My 94 Camaro is step child but that was named by my buddy i bought it off of
My turbo ZX14 is just...
Forum: Tuning / Diagnostics 03-08-2024, 12:13 PM
Replies: 18
Views: 1,258
Posted By jlaudio11
I’m wondering about other capabilities of the dsx...

I’m wondering about other capabilities of the dsx setup as well. My reflex used to control boost, I’m now running an ams 1000 but it does still pwm my auxiliary fuel pump. I will need to do...
Forum: Tuning / Diagnostics 03-07-2024, 09:26 AM
Replies: 18
Views: 1,258
Posted By jlaudio11
From my understanding the DSX kit is going to...

From my understanding the DSX kit is going to integrate and work like the fords do with dual injection. You basically put in the percentage of port you want in the hptuners tune file, the ecm knows...
Showing results 1 to 30 of 208
Page 1 of 7 1 2345 Last »

 
Forum Jump

All times are GMT -5. The time now is 01:18 PM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.