The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums
Reload this Page Search Results

Showing results 1 to 22 of 22
Search took 0.00 seconds. Search: Posts Made By: Audio_Rookie
Forum: Transmissions 12-30-2023, 10:58 PM
Replies: 8
Views: 3,686
Posted By Audio_Rookie
Ya even the solid bar tapers down after the...

Ya even the solid bar tapers down after the splines though :( I was hoping I could just machine factory ones shorter. Really went down this rabbit hole. Here :(
Forum: Transmissions 11-29-2023, 01:41 AM
Replies: 8
Views: 3,686
Posted By Audio_Rookie
The rear mounts on the fifth Gen vs sixth Gen...

The rear mounts on the fifth Gen vs sixth Gen cradle is very different. I would likely end up modifying the cradle to make a fifth Gen diff work. The zl1 units are so dang expensive now though what...
Forum: Transmissions 11-29-2023, 01:23 AM
Replies: 3
Views: 2,047
Posted By Audio_Rookie
I actually bought that diff you are referring to...

I actually bought that diff you are referring to but from speed master as nitro was unable to get it. It does not fit the sixth Gen stuff. Ring gear size different, width of pumpkin different….
...
Forum: Transmissions 08-15-2023, 01:05 PM
Replies: 8
Views: 3,686
Posted By Audio_Rookie
Yes I have a 2010 Camaro with a ZL1 rear. I was...

Yes I have a 2010 Camaro with a ZL1 rear. I was under the impression the “gravedigger” was a fifth gen zl1 diff or pumpkin that was adapted to a sixth gen.

These are only rumours more or less as I...
Forum: Transmissions 08-14-2023, 11:25 PM
Replies: 8
Views: 3,686
Posted By Audio_Rookie
Remove ELSD? options? 2020 1LE

Long time reader seeking knowledge :p

I have combed through the DIY and the last few years of this category and I cannot seem to find almost any info about this.....I guess who would want to...
Forum: Forced Induction - V6 08-24-2017, 01:44 PM
Replies: 3
Views: 1,514
Posted By Audio_Rookie
I would think 38mm would be plenty sufficient...

I would think 38mm would be plenty sufficient depending on how low of boost you want to be able to regulate on that 3.6

I have a 46mm precision unit feeding a single 76mm on a 6.0 and I can drop...
Forum: Canada 08-10-2017, 03:44 PM
Replies: 818
Views: 89,593
Posted By Audio_Rookie
I'm stuck in llyod right now but I am an Edmonton...

I'm stuck in llyod right now but I am an Edmonton guy :p
Forum: Forced Induction - V8 08-06-2017, 02:00 PM
Replies: 14
Views: 7,096
Posted By Audio_Rookie
Here are some pictures I have with me on my...

Here are some pictures I have with me on my phone. I built the hot side using 2 passenger side truck exhaust manifolds, built a crossover pipe under the tranny and then on the driver side I welded a...
Forum: Forced Induction - V8 08-06-2017, 12:23 PM
Replies: 14
Views: 7,096
Posted By Audio_Rookie
I made my own kit as I swapped a iron 6.0. ...

I made my own kit as I swapped a iron 6.0.

It's a lot of fab work and I am a journeyman steamfitter/pipefitter as well as plumber/gasfitter so I was pretty confident in my piping fit-up.

That...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-28-2017, 01:33 AM
Replies: 13
Views: 2,693
Posted By Audio_Rookie
It should be a bolt in. I am up in Canada and...

It should be a bolt in. I am up in Canada and this is who I used. They were the cheapest when I bought a zl1 fuel pump too.

https://www.gmpartswholesale.ca/oem-parts/gm-transmission-24261736

I...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-27-2017, 10:52 AM
Replies: 13
Views: 2,693
Posted By Audio_Rookie
I just bought a brand new mm6 tranny from gm for...

I just bought a brand new mm6 tranny from gm for about $2500 US. This is the stock tranny from the 1LE/z28 car, rated for more power and cheaper than the m10.

I was also looking at the mg9 from...
Forum: Transmission / Driveline 07-16-2017, 01:08 PM
Replies: 2
Views: 1,141
Posted By Audio_Rookie
Bought a new tranny from gm. No longer in the...

Bought a new tranny from gm. No longer in the market.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-11-2017, 03:01 PM
Replies: 2
Views: 1,516
Posted By Audio_Rookie
Being someone who has replaced atleast half a...

Being someone who has replaced atleast half a dozen wheel bearings....it sure sounds like one to me, especially if it gets better when you turn right (even a little)

Once your brakes stop working...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-11-2017, 10:14 AM
Replies: 5
Views: 3,302
Posted By Audio_Rookie
I just don't get why this won't mate to a clutch...

I just don't get why this won't mate to a clutch and flywheel that is on a 6 bolt crank, if the pilot support and the spline in the clutch is the same. The same starter and bellhousing size I would...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-10-2017, 11:00 PM
Replies: 5
Views: 3,302
Posted By Audio_Rookie
I don't want ultimate power. I am about maxed on...

I don't want ultimate power. I am about maxed on stock block strength and fuel system. I want to enjoy this ride for a few years trouble free and probably sell.

The prices are pretty reasonable...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-10-2017, 09:30 PM
Replies: 5
Views: 3,302
Posted By Audio_Rookie
Mg9 tr6060 swap?!

So I'm in the market for a tr6060 and I have been looking at my options.

I am open to the idea of buying a new tranny from Gm and have been researching part numbers, gearing, etc.

Seems the...
Forum: Transmission / Driveline 07-09-2017, 09:42 AM
Replies: 2
Views: 1,141
Posted By Audio_Rookie
Bump up, still searching

Bump up, still searching
Forum: Transmission / Driveline 07-02-2017, 10:51 AM
Replies: 2
Views: 1,141
Posted By Audio_Rookie
Wtb: tr6060 transmission

So I bought a 2010 camaro ss off a kid with an apparently "built" transmission (rpm lvl 4). Once I got a new engine in the car and was driving it, it wouldn't shift into 2nd or fourth gear...and made...
Forum: Transmission / Driveline 07-01-2017, 07:49 PM
Replies: 4
Views: 1,903
Posted By Audio_Rookie
I may be interested in only the tranny if that's...

I may be interested in only the tranny if that's the case....
Forum: Transmission / Driveline 07-01-2017, 05:05 PM
Replies: 14
Views: 2,422
Posted By Audio_Rookie
Think I have the wrong email for payment. Getting...

Think I have the wrong email for payment. Getting mail delivery failure when emailing.
Forum: Transmission / Driveline 07-01-2017, 01:15 PM
Replies: 14
Views: 2,422
Posted By Audio_Rookie
Payment sent.

Payment sent.
Forum: Transmission / Driveline 06-29-2017, 05:16 PM
Replies: 14
Views: 2,422
Posted By Audio_Rookie
Pm sent

Pm sent
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -5. The time now is 07:45 AM.

Contact Us - Chevrolet Corvette Stingray C7 Forum - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.