codes p0300 and p16a1 and p0157
ok so did some upgrades: halltech intake, katech ported tb, borla h pipe and granatelli plug wires. car started fine for a few minutes then felt sluggish and flashing check engine light came on with service stabilitrak and service rear diff light on dash checked code and was only p0300 so re-seated all plug wires and they are all good checked all hoses under hood and all connected. with getting the lean code do i need to get this tuned? :frusty: not sure what the heck my issue is at this point?
|
Sorry 2015 c7 z51
|
ok went out to look at this again and changed out the tb to the stock one. cleared the codes and getting a permanent code of a p0300 and p16a1 with the pending code of a p0300 and the serv stabilitrack and serv rear diff and flashing check engine code
|
ok bought hp tuners and seeing a misfire on 7 and 8 how do the cylinders count on the block?
|
Sounds like a misfire issue. Try replacing the plugs and wires.
|
All times are GMT -5. The time now is 10:22 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.