ZL1 Hood Extractor
 

Would someone please measure their Camaro ZL1 "Mohawk" hood extractor on top of the hood and please get me some dimensions in inches? :thumb: :hail:

This piece?
http://www.gen5diy.com/image/cache/d...12-600x600.jpg

Bump, I hope I didn't ask for some top secret numbers :bonk: I just want to measure if it will fit on my hood. I know it will fit a Camaro stock hood, but I don't have one :)

im not sure that piece from acs is exactly the same size as gm unit. you could call acs and see what the dimensions are.

are you planning on putting the heat extractor on a c4? that might be cool.

I was probably actually going to order the one from phastek because i found the whole kit to go on the base and ss camaros. I am planning on putting it on my C4 because I want more down force along with heat extraction. Haven't found a splitter for the C4 that I like though.. :nod:

Haha so many views and no replies? It would take less than five minutes. Can someone please just take a quick measurement?

I am pretty sure the ACS one is the same size as the ZL1 extractor, they sell one for each hood and it's my understanding the only difference is the way they are mounted. The ZL1 hood extractor has mounting points the same as the Factory ZL1 extractor because the ZL1 hood has the cutout made for it.

I agree, I am just wondering the measurements so I know how well it will cover my stock cowl.

don't understand why you need to measure, look up acs tl1 and there you go thats what it will look like

http://images-cdn.ecwid.com/images/87523/62069931.jpg

Because I don't want to spend $550 dollars on a heat extractor that hang over the sides of my hood cowl.

Thank you, but I have already googled a ZL1 hood extractor on a C4 corvette. No one has done it.

failed to see that you were putting it on your corvette...

It's all good! :pop2: