You are browsing camaro6 
03-15-2018, 12:55 PM
|
#1 |
    
Drives: 18 Camaro ZL1 1LE (WILSON) Join Date: Jul 2009
Location: N.C.
Posts: 1,340
|
ARH 1 7/8 Headers with Long system install
I am installing the ARH 1 7/8 Headers with the long system on my 2018 ZL1 1LE. I searched the forum but did not find what I am looking for.
Where do I cut the pipe at to hook the long system into the Factor Muffler? I know I cut it after the smashed part of the pipe but what do I measure on and what is the measurement?
__________________
|
|
|
|
03-15-2018, 01:18 PM
|
#2 |
    Drives: 17 Camaro SS 1LE & 16 Sierra AT CC Join Date: Nov 2016
Location: Norman, OK
Posts: 2,424
|
The install should tell you, it is around 6"-12" before the muffler where you cut.
|
|
|
|
|
03-15-2018, 01:22 PM
|
#3 | |
|
Drives: 18 Camaro ZL1 1LE (WILSON) Join Date: Jul 2009
Location: N.C.
Posts: 1,340
|
Quote:
Sent from my SM-G900P using Tapatalk
__________________
|
|
|
|
|
|
03-15-2018, 05:26 PM
|
#4 |
|
Markoon13
Drives: Camaro 2SS Join Date: Oct 2016
Location: San Diego
Posts: 853
|
If you are unsure then just cut the pipe in the back extra long just to be safe, start to install the system and see where it lines up to.
__________________
|
|
|
|
|
03-18-2018, 03:10 AM
|
#5 | |
   
Drives: 2017 2SS M6 Join Date: Jun 2013
Location: WNY
Posts: 7,071
|
mine came with no instructions. what I did is put the new on top of the old and lined up the rear hangers. mark the old and cut. on mine it was 13" from the rear hangers to the cut. it gives you quite a bit of leeway. to make sure the tips are equal look at your hangers. there will be a polished line on the rear hangers. just move the muffler to were it was befor.
__________________
real ZL1 wheels and brakes, 285/305 Michelin Pilot Super Sports, Pray ported Intake manifold, Soler Throttle Body, Rotofab intake, EFI Tuning Flex fuel kit, full American Racing Headers Exhaust, 1 7/8" w/ cats H pipe and mufflers. Full 1LE suspension, with BMR adjustable sway bars and links, GM aluminum cradle bushings, Hurst shifter with lighter reverse spring, TWM shifter knob, Tick level 1 transmission. I should have bought a ZL1
|
|
|
|
|
|
03-20-2018, 07:56 AM
|
#6 |
|
Drives: 18 Camaro ZL1 1LE (WILSON) Join Date: Jul 2009
Location: N.C.
Posts: 1,340
|
I got my headers and my new CAI installed and I am very pleased with the ARH headers and the cols air inductions CAI.
__________________
|
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
