|
I ordered it to go on my zl1 hood so Ill know what the quality looks like next week.
"The carbon fiber weave is set in the mold, and graphite epoxies are applied under vacuum to push the epoxy through the fibers until the correct consistency and equally distributed expoxy over the entire surface of the piece is achieved. The piece is then cured, tested for accurate density throughout the form, and either accepted as accurate and complete, or discarded. This is often referred to as “infused” carbon fiber."
Seems to be legit carbon fiber.
Im not so sure it matters if they include gaskets or not. I mean wouldn't it be easy to run down to the hardware store and pick up a few thin rubber gaskets? That is my plan.
|