Quote:
Originally Posted by Lio Martinez
Ok so I also got a Set of the Pfadt Front sway bar end links . Will those still work with the sway bars you are planning to make and sell!?
|
Quote:
Originally Posted by Apex Chase
Yes, they will be completely unchanged. You should have no problems using the Pfadt end inks.
|
Not completely true. Lio, if you got a hold of a set that were for the earlier Pfadt racing sways, they will have the 10mm heim joint on both ends. For the ZL Spec sway you need the 12mm thread. The bar uses the 12mm hole like the ZL1 does. The end links that came with the ZL1 Spec bars had 10mm on one end and 12mm on the other. The 10mm hole is for attaching to the strut. The ZL1 end links are 12mm on both ends and some guys just drill the strut hole larger. I believe you have the Pfadt coil overs so you have the 10mm hole.
Other than the heim joint thread size they are the same.