I just got some "Camaro RS" black steel frames, but unfortunately I can't use them with my new Oregon plates as they cover up more than 2/3s of the stickers (front & back have stickers) I looked at how much would need to be ground down there's two problems with it: 1. even if I grounded a little bit off it would not be enough to show more of the sticker and 2. it would ultimately ruin the frame.
The other option is to just turn it upside down (that's what we do when it doesn't fit right) which is silly... then "Camaro RS" is going to be upside down too, does anybody have any ideas what I can do? I can't move the sticker up higher and even if I could it wouldn't be legal; cutting the plate at the top wouldn't work either and Oregon law does not permit any modification of the plates either (this is about a $700 fine PER plate)
Seems like most Oregonians don't even have license plate bracket/frames because most of them cover up the sticker... what a silly joke.
Here's the frame I got:
http://www.ebay.com/itm/151237375367...S:1120&vxp=mtr