I've been working with MRR to get custom sized FS06 rims in gloss black. I don't want 10" front rims, because I want to run 275/35's and don't think they would look ideal on 10".
I'm looking for a flush no poke look in the front and rear
So far I spec'd out:
Front 9.5x20 w/+20 offset for Atturo 275/35/20
Rear 11x20 w/+40 offset for Atturo 315/30/20.
Question is, do 315/30's fully clear the wiring harness with the normal +43 ?, if not, would the +40 clear it? Is there any poke with 315/+43 ?
In the front I was planning on a 9.5"+20 rim with 275/35's, but I'm worried about poke. The online calculator shows 1/8" less poke than a 10"+23 rim with a 285. Do 285+23 rims poke, and if so approximately how much ?
|