|
i just had a new input shaft installed in my trans this week and it has the same machining marks on the new shaft as shown in your pictures. I am on clutch number 4 over time and I could see difference in the amount of play of the disk on the shaft from one clutch to another. With the clutch disk on the shaft, hold the outer edges and see if it wobbles by pushing one side forward and one side back like when you are removing a wheel from a car.
Loose clutch splines and dry splines were two items I ran into. Unfortunately, if the input shaft is bad, all the internals have to be removed on a tr6060 as it cannot come out the front.
|