|
2011 SS M6 won't go into gear after cam swap
Just got done doing the cam swap over the weekend and it was a success thanks to the diy. It Was my first time doin anything that big. (not that big to some I know) I pulled the car out the garage after finishing to turn it around to let run and change the oil. Seemed fine that I can remember. Went to take the car to get tuned a couple hours later and it won't go into gear. If I start the car up in gear with the clutch in the car starts goin forward. If i hold the gear shift forward trying to put it in gear the car moves forward also (even with the clutch in) With the engine off the car goes into all gears. I'm wondering if there is anything I could of did to cause this while doin the cam swap or just bad timing. Any help or Info about the situation is appreciated. I've tried searching but haven't found anything so I'm thinking it's just bad timing and something is wrong with the clutch setup.
|