The 2014 Corvette Stingray Forum
News / Blog Register Community Calendar Today's Posts Search

Go Back   Chevrolet Corvette Stingray C7 Forum > Search Forums

Showing results 1 to 30 of 500
Search took 0.11 seconds.
Search: Posts Made By: CamaroCracka
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-01-2024, 07:22 PM
Replies: 11
Views: 545
Posted By CamaroCracka
Now that you mention it, I think I used masking...

Now that you mention it, I think I used masking tape before I took the hood off.
Forum: Forced Induction - V8 05-01-2024, 08:22 AM
Replies: 13
Views: 469
Posted By CamaroCracka
Meth or E85, if you are putting down 700+ at 7...

Meth or E85, if you are putting down 700+ at 7 lbs, add one and increase the boost. You will definitely make more power and should not be at risk at higher boost levels. E85 will cost more because...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-29-2024, 04:43 PM
Replies: 11
Views: 545
Posted By CamaroCracka
I must be getting lucky with the hood alignment...

I must be getting lucky with the hood alignment as this is the first I heard of the hole drilling trick. Never needed more than a couple adjustments. I made my daughter help me on the vert since she...
Forum: Forced Induction - V8 04-29-2024, 04:33 PM
Replies: 13
Views: 469
Posted By CamaroCracka
Agree with Tartaglia, if meth added 100hp...

Agree with Tartaglia, if meth added 100hp everyone would run it. You also don't need multi-stage, just use a progressive controller with a solenoid. You can run as many jets as you like.

If you...
Forum: Camaro 1LE Forum 04-29-2024, 04:20 PM
Replies: 8
Views: 3,041
Posted By CamaroCracka
Looks like RockAuto still has some right side Z28...

Looks like RockAuto still has some right side Z28 axles, but I have not seen any 1LE axles for a while. Pretty sure GM discontinued them.
Forum: Forced Induction - V8 04-26-2024, 01:40 PM
Replies: 13
Views: 469
Posted By CamaroCracka
To be on the safe side, a lot of people only run...

To be on the safe side, a lot of people only run meth as insurance. In other words, they don't make the tune dependent on the additional "octane" it provides. Of course, then you leave a lot of the...
Forum: ZL1 Wheels/Tires 04-25-2024, 08:53 AM
Replies: 2
Views: 250
Posted By CamaroCracka
Same as SS 14mx1.5.

Same as SS 14mx1.5.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-23-2024, 07:16 AM
Replies: 3
Views: 274
Posted By CamaroCracka
a compressor can be failing and still deliver...

a compressor can be failing and still deliver cold air. You would have to connect some gauges and see what the high and low pressures are.

I had to replace the compressor on my turbo car because...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-23-2024, 06:54 AM
Replies: 11
Views: 545
Posted By CamaroCracka
I've done it multiple times. Get some fender...

I've done it multiple times. Get some fender covers so you can lay the condenser on the passenger side without fear of scratching the paint. You can even leave the trans hooked up but you will need...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-23-2024, 06:40 AM
Replies: 7
Views: 492
Posted By CamaroCracka
You have to do the cost benefit analysis for...

You have to do the cost benefit analysis for yourself. Anyone running boost can see big benefits by running e85. For those not running boost, my rule of thumb would be if the use of race fuel would...
Forum: Forced Induction - V8 04-22-2024, 11:31 AM
Replies: 13
Views: 469
Posted By CamaroCracka
I ran meth until I went e85. The nylon lines and...

I ran meth until I went e85. The nylon lines and fittings tend to leak over time and reassembly when your working on the car. Never had a problem with the Snow pump, but their controller died and...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-21-2024, 03:01 PM
Replies: 2
Views: 345
Posted By CamaroCracka
I had an Ideal Garage master cylinder and ended...

I had an Ideal Garage master cylinder and ended up going back to OEM because it was leaking internally. All the clutch issues I've had on both cars in relation to pedal not coming back were fixed...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-18-2024, 07:57 AM
Replies: 6
Views: 440
Posted By CamaroCracka
You would have to turn it hard enough for the...

You would have to turn it hard enough for the carrier's internal clutches to slip.
Forum: Forced Induction - V8 04-17-2024, 06:53 AM
Replies: 14
Views: 650
Posted By CamaroCracka
I don't run a shield on my heater lines and the...

I don't run a shield on my heater lines and the passenger side header even burnt the foam off the aluminum line. I do tuck a lot behind the heat shield that runs up from the trans tunnel and covers...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-17-2024, 06:48 AM
Replies: 10
Views: 640
Posted By CamaroCracka
All manufacturers eventually discontinue all...

All manufacturers eventually discontinue all parts. If you want to race old iron, you either need to invest in a stock of used parts or buy replacements from the aftermarket. DSSVs were over a grand...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:24 PM
Replies: 12
Views: 640
Posted By CamaroCracka
Summit has a 415 short block for $4200, $6200 for...

Summit has a 415 short block for $4200, $6200 for GM LS3 long block. When my vert spun a rod I had a 416 built for 7k and installed for another thousand. That included a new clutch and a cam swap.
...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:09 PM
Replies: 11
Views: 528
Posted By CamaroCracka
Looks like the Spohn brace with the two...

Looks like the Spohn brace with the two additional sides to make a triangle. It might be good if you wanted to cut out the cross member to remove the oil pan and not replace it. One guy did that with...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:06 PM
Replies: 11
Views: 624
Posted By CamaroCracka
I like the ones with the chrome naked lady on...

I like the ones with the chrome naked lady on them.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-16-2024, 02:03 PM
Replies: 3
Views: 315
Posted By CamaroCracka
You may have four front wheels on the car....

You may have four front wheels on the car. Measure the inside of the tire barrels to see if they are the same width. Stock wheels are 20x8 and 20x9. You can also look on the back of the wheel and see...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-15-2024, 08:50 AM
Replies: 25
Views: 876
Posted By CamaroCracka
Pretty sure the Mantic instructions said a light...

Pretty sure the Mantic instructions said a light coat of grease on the input shaft. I could be wrong, but I did the same thing, sliding the clutch discs on to the input shaft to make sure they were...
Forum: Forced Induction - V8 04-15-2024, 08:41 AM
Replies: 14
Views: 650
Posted By CamaroCracka
I don't have AGP, but my single set up loves to...

I don't have AGP, but my single set up loves to melt loom in that area. This stuff holds up to the heat better than any other loom I have found, except maybe the silicone covered stuff, which is not...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-10-2024, 07:33 PM
Replies: 6
Views: 231
Posted By CamaroCracka
My fan plug burned with just the stock fans...

My fan plug burned with just the stock fans running on it. I would definitely just tap into the fan feed as trigger for an additional relay with a separate power source.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-09-2024, 02:29 PM
Replies: 39
Views: 1,755
Posted By CamaroCracka
Definitely, maybe it was because mine was built...

Definitely, maybe it was because mine was built during Covid, but I twisted it in half at a lot less power. Looked to me like the weld penetration was bad and it was taken care of, but it makes me...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 04-07-2024, 12:30 PM
Replies: 9
Views: 660
Posted By CamaroCracka
That half liter difference between the SS and Zl1...

That half liter difference between the SS and Zl1 TR6060s is the cooler lines and cooler. When I put diff coolers on my cars they took approximately 4.5 quarts to refill with the cooler in place.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-07-2024, 12:21 PM
Replies: 19
Views: 1,206
Posted By CamaroCracka
The stock 355 l99 pump can cavitate at high rpm...

The stock 355 l99 pump can cavitate at high rpm aerating the oil. They used to run a similar pump in the LS4 5.3 that I ran for a while in another engine. Low cost pump that builds tons of pressure,...
Forum: Suspension / Brakes / Chassis 04-07-2024, 12:13 PM
Replies: 6
Views: 475
Posted By CamaroCracka
Here is what I have.

Here is what I have.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2024, 10:47 AM
Replies: 1
Views: 203
Posted By CamaroCracka
Long duration cams respond well to steeper gears....

Long duration cams respond well to steeper gears. Superchargers tend to need less gear but centrifugals come in later so you should be ok if you don't get too crazy on the power level.
Forum: 5th Gen Camaro SS LS LT General Discussions 04-02-2024, 05:25 AM
Replies: 9
Views: 365
Posted By CamaroCracka
The front is the harder part to get in the air,...

The front is the harder part to get in the air, if you get a long reach, low profile jack, you won't need any blocks to get a jack under it. Hell, even at stock height you really need a long reach,...
Forum: Chevy Camaro vs... 04-01-2024, 02:14 PM
Replies: 11
Views: 10,606
Posted By CamaroCracka
That would have actually been a very cool option...

That would have actually been a very cool option as there are so many turbo 5.3s you would have had turbo Gen6s everywhere. Reminds me of the low option muscle cars we drove in the 80s. We could not...
Forum: Forced Induction - V8 03-29-2024, 07:43 AM
Replies: 2
Views: 327
Posted By CamaroCracka
I'm at about that at WOT on E85 using a AEM gauge.

I'm at about that at WOT on E85 using a AEM gauge.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:42 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.