Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
Page 4 of 4 123 4
Show 40 post(s) from this thread on one page

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (https://www.camaro5.com/forums/index.php)
-   Camaro ZL1 Forum - ZL1 Specific Topics (https://www.camaro5.com/forums/forumdisplay.php?f=85)
-   -   Cost for 700hp? (https://www.camaro5.com/forums/showthread.php?t=354801)

blk13 04-26-2014 10:06 AM
Id850s but if i was going to make anymore power i would step it up to just alittle bigger.

Quote:
Originally Posted by AZ-ZL1 (Post 7613622)
Thats a bargain...what size injectors did you need for the e85 ?

Blown355 04-26-2014 10:13 AM
Quote:
If I had the lift equipment I would put my headers and etc on myself to avoid labor costs, etc. Thats a lot to pay for labor to get to 700. Though time is money, I value my money more than the day or 2 or however many it takes for install.

Sent from my iPad using Tapatalk
Save yourself some money and do the header install yourself. With two jacks and basic hand tools it took me three and a half hours start to finish.

Blown355 04-26-2014 10:22 AM
Quote:
Originally Posted by Baer383 (Post 7612341)
Yeah,I used normal 6 ton jack stands got under the car put the header up toward the top of the engine, the header stood there the collector end sitting on the floor,went to the top and pulled the header right up,this was the easiest set of headers I've ever put in.
+1

BumblebeeQ8 04-27-2014 02:38 AM
is it OK to install pulley's but without Headers ?

hotlap 04-27-2014 07:19 AM
Quote:
Originally Posted by Baer383 (Post 7612341)
Yeah,I used normal 6 ton jack stands got under the car put the header up toward the top of the engine, the header stood there the collector end sitting on the floor,went to the top and pulled the header right up,this was the easiest set of headers I've ever put in.
This is good new! I really enjoy doing my own work but was concerned about stands not providing enough room.

I'm going with Roto Fab CAI, Kooks long tubes and cats, 2.55 upper pulley and a tune. 1300 more miles until I hit the magic number. Weather still is hit or miss here so it's bee hard to get her out

Baer383 04-27-2014 07:22 AM
Quote:
Originally Posted by hotlapZL1 (Post 7615921)
This is good new! I really enjoy doing my own work but was concerned about stands not providing enough room.

I'm going with Roto Fab CAI, Kooks long tubes and cats, 2.55 upper pulley and a tune. 1300 more miles until I hit the magic number. Weather still is hit or miss here so it's bee hard to get her out
I also installed Kooks headers but only waited 300 miles to tear into the short block.lol


All times are GMT -5. The time now is 09:19 PM.
Page 4 of 4 123 4
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.